17 February 2005 in Polymers for Advanced Technologies
12 January 2010 in IEEE Transactions on Information Technology in Biomedicine
Spatial and temporal plantar pressure distributions are important and useful measures in footwear evaluation, athletic training, clinical gait analysis, and pathology foot diagnosis. However, present plantar pressure measurement and analysis systems are more or less uncomfortable to wear and expensive. This paper presents an in-shoe plantar pressure measurement and analysis system based on a textile fabric sensor array, which is soft, light, and has a high-pressure sensitivity and a long service life. The sensors are connected with a soft polymeric board through conductive yarns and integrated into an insole. A stable data acquisition system interfaces with the insole, wirelessly transmits the acquired data to remote receiver through Bluetooth path. Three configuration modes are incorporated to gain connection with desktop, laptop, or smart phone, which can be configured to comfortably work in research laboratories, clinics, sport ground, and other outdoor environments. A real-time display and analysis software is presented to calculate parameters such as mean pressure, peak pressure, center of pressure (COP), and shift speed of COP. Experimental results show that this system has stable performance in both static and dynamic measurements.
1 September 2006 in Materials Science and Engineering: B
1 January 2007 in Ultrasonics Sonochemistry
Conventionally, micro-sized irregular polyaniline (PANI) particles were synthesized by dropwise addition of the ammonium persulfate (APS) solution into the aniline (ANI) solution with mechanical stirring. By replacing the mechanical stirring with an ultrasonic irradiation, PANI nanofibers in diameters of approximately 50 nm and lengths of 200 nm to several micrometers were prepared. Transmission electron microscopy (TEM) and scanning electron microscopy (SEM) showed that at the early stage of polymerization, the polymers formed in both the mechanical stirred and ultrasonicated systems are in the form of nanofiber. However, with continuing of the reaction, these primary nanofibers grow and agglomerate into irregular shaped PANI particles in the mechanical stirred system, while in the case of the ultrasonic irradiation, the growth and agglomeration are effectively prevented, preserving thus the PANI nanofibers in the final product. By increasing the APS/ANI molar ratio from 0.5 to 2.5, the aspect ratios of the PANI nanofibers decreased. The PANI nanofibers exhibit higher solubility than the irregular shaped PANI particles. Although the yield, as well as the conductivity of the ultrasonic synthesized PANI nanofibers, was slightly lower than the irregular shaped PANI particles, the ultrasonic synthesis approach is one of the facile and scalable approaches in synthesizing PANI nanofibers in comparison with other ones without use of templates (e.g., the interfacial polymerization and rapid mixing polymerization). UV-Vis and Fourier transformed infrared (FTIR) spectra indicated ultrasound had no significant effect on the chemical structure of the PANI.
1 August 2012 in Polymer Testing
1 January 2008 in The Journal of Physical Chemistry B