Composition dependence of second harmonic generation, refractive index, extinction coefficient, and optical bandgap in 20 nm thick crystalline Hf1−xZrxO2 (0 ≤ x ≤ 1) thin films is reported. The refractive index exhibits a general increase with increasing ZrO2 content with all values within the range of 1.98–2.14 from 880 nm to 400 nm wavelengths. A composition dependence of the indirect optical bandgap is observed, decreasing from 5.81 eV for HfO2 to 5.17 eV for Hf0.4Zr0.6O2. The bandgap increases for compositions with x > 0.6, reaching 5.31 eV for Hf0.1Zr0.9O2. Second harmonic signals are measured for 880 nm incident light. The magnitude of the second harmonic signal scales with the magnitude of the remanant polarization in the composition series. Film compositions that display near zero remanent polarizations exhibit minimal second harmonic generation while those with maximum remanent polarization also display the largest second harmonic signal. The results are discussed in the context of ferroelectric phase assemblage in the hafnium zirconium oxide films and demonstrate a path toward a silicon-compatible integrated nonlinear optical material.
Aluminum scandium alloys and their intermetallic phases have arisen as potential candidates for the next generation of electrical interconnects. In this work, we measure the in-plane thermal conductivity and electron–phonon coupling factor of aluminum scandium alloy thin films deposited at different temperatures, where the temperature is used to control the grain size and volume fraction of the Al3Sc intermetallic phase. As the Al3Sc intermetallic formation increases with higher deposition temperature, we measure increasing in-plane thermal conductivity and a decrease in the electron–phonon coupling factor, which corresponds to an increase in grain size. Our findings demonstrate the role that chemical ordering from the formation of the intermetallic phase has on thermal transport.
Dielectric amorphous multilayers (AMLs) play a critical role in a wide array of technologies such as optical coatings, nanoelectronics, energy harvesting, and recovery devices. However, despite their wide applications, a robust understanding of the effect of the interplay between chemical and structural disorder on the thermal properties of AMLs is still lacking. Therefore, in this paper, we experimentally and numerically investigate the effects of composition and interface density on the sound speed and thermal conductivity of a series of amorphous aluminum nitride and aluminum oxide multilayers grown via plasma-enhanced atomic layer deposition. To systematically change the composition, the oxygen content of the AMLs is proportionally varied with interface density during growth. We find that the longitudinal sound speed of these AMLs is dictated by the oxygen content instead of the number of interfaces. The thermal conductivity, in contrast, is dictated by both interface density and oxygen content. The interfaces act to decrease the thermal conductivity, whereas the oxygen content increases the thermal conductivity. Due to the competing influence of the interfaces and oxygen content, the thermal conductivity of the AMLs remains nearly constant as a function of interface density. Our study provides crucial insights into the effect of the interplay of composition and interfaces on the sound speed and thermal conductivity of AMLs.
The Wiedemann–Franz (WF) law correlates heat and charge transport in metals. However, the validity of this correlation remains an open-ended question, especially in the context of inelastic scattering at room temperature. To address this gap in knowledge, we perform independent measurements of the in-plane thermal and electrical conductivities across four AlCu (0.5% Cu) films [thickness (h) ≈ 174, 98, 53, and 24 nm] using optical pump–probe metrologies and four-point probe techniques, respectively. For in-plane thermal conductivity measurements, we utilize time-domain thermoreflectance, in both concentric and beam-offset configurations, and the time-resolved magneto-optic Kerr effect. Our results show that the WF law overpredicts the thermal conductivity by at least ∼10% in all films, thus demonstrating modest deviations in predicted thermal conductivity when applying the WF law to dilute AlCu films. Using infrared variable angle spectroscopic ellipsometry, we demonstrate increased electron scattering rates in the thinnest film (h≈ 24 nm), indicating electron-boundary scattering drives the reduction in in-plane thermal conductivity. This is generally an elastic scattering process, which is supported by our thermal conductivity measurements and analysis.