The model of a photoacoustic gas-microphone signal in the time domain recorded in a transmission configuration using a minimum volume cell is derived. This mode
Semiconductor physics represents one of the most dynamic areas of materials science and solid-state physics. Modern electronics uses a wide range of semiconduct Semiconductor physics represents one of the most dynamic areas of materials science and solid-state physics. Modern electronics uses a wide range of semiconduct
6 July 2012 in International Journal of Thermophysics
When a semiconducting sample is illuminated by an intensity-modulated monochromatic light beam with photon energy exceeding the band gap, part of the absorbed energy is directly converted into heat through photon–lattice interactions. This gives rise to a heat source that closely follows the temporal profile of the optical excitation, known as the fast heat source. Simultaneously, another portion of the absorbed energy is used to generate electron-hole pairs. These charge carriers diffuse together and recombine via electron–electron and electron–hole interactions, transferring their kinetic energy to the lattice and producing additional heating of the sample. This indirect heating mechanism, associated with carrier recombination, is referred to as the slow heat source. In this study, we develop a model describing surface temperature variations on the non-illuminated side of a thermally thin semiconductor exposed to a rectangular optical pulse, explicitly accounting for the contribution of surface charge carrier recombinations. Using this model, we investigate the influence of surface recombination velocity and the material’s plasma properties on the time-domain temperature response for both plasma-opaque and plasma-transparent samples. Our results demonstrate that charge carrier recombinations can significantly affect the transient photoacoustic signal recorded using a minimum volume cell, highlighting the potential of time-resolved photoacoustic techniques for probing the electronic properties of semiconductors.
22 May 2013 in International Journal of Thermophysics
In an optically excited semiconductor micromechanical structure, photogenerated carriers (plasma waves) can produce elastic deformations (local strains and stresses)–plasmaelastic (PE) deformations. On the other hand, the generation of excess carriers will produce heat due to carrier thermalization and recombination processes. The generated heat can produce other elastic deformations–thermoelastic (TE) deformations. For these two components of elastic deformation, it is possible to consider two types of elastic displacements (two mods of elastic vibrations): elastic expanding and elastic bending. A theoretical model of the photoacoustic (PA) signal for optically excited Si membranes is given, which includes thermal diffusion (TD), TE, and PE mechanisms, in order to study elastic expansion and bending. The relations for the PA amplitude and the phase of elastic expanding and bending in the excited membrane are derived. Analysis of the PA signal indicates that the TD component is dominant for all thicknesses and practically the entire range of observed frequencies. The calculated PA amplitude and phase spectra show that the PA elastic expanding component has a significant influence on the total PA signal at low frequencies. On the other side, the calculated PA spectra show that the PA elastic bending component has a significant influence on the total PA signal at high frequencies. Experimental PA signals of Si membranes were measured using the sample-gas-microphone detection technique with a transmission configuration in relation to the modulation frequency of the optical excitation for different membrane thicknesses. The experimental PA spectra were compared with the theoretical ones.