Compatibility between tritium self-sufficiency and neutron shielding performance of self-cooled liquid blanket systems without solid neutron multiplier was investigated for the purpose of application to the conceptual helical reactor design of modified FFHR2 having the blanket space of 120 cm. The results of the neutronics calculation indicated that all of the Li/V-alloy, Flibe/V-alloy and Flibe/JLF-1 (Reduced Activation Ferritic steel) blankets are feasible for tritium breeding ability and neutron shielding performance. With the use of vanadium alloys, operation efficiency will be enhanced.
Synthetic diamond radiation detectors made of ultrahigh-purity type IIa diamond crystals were developed. The diamond crystals, which were grown by high-pressure and high-temperature synthesis, contained less nitrogen impurity than 0.1 ppm, i.e., 1/10 of conventional type IIa diamond crystals. Since the ultrahigh-purity type IIa diamond crystal was a p-type semiconductor due to a trace impurity of boron, a structure consisting of Schottky and ohmic contacts was adopted for the detectors to suppress an increase in leakage current. For the same purpose, a metal–insulator–semiconductor structure using a chemical vapor deposition diamond insulating layer was adopted for one of the detectors. Plural peaks were observed in the 5.486 MeV α energy spectra obtained by the detectors; motion of holes produced the main part of output pulses from the detectors on these measurements. One of the peaks in each spectrum was hardly influenced by light irradiation, even ultraviolet light of 370 nm (3.4 eV), compared with a peak obtained by the conventional type IIa diamond radiation detector. This experimental result indicated that there was a superior part in the crystal where deep energy levels did not exist so much. Although there was no direct evidence, influence of a distribution of the boron impurity in the crystal was expected. On the other hand, electron trapping severely occurred and resulted in loss in charge collection; an effect of the reduction in the nitrogen impurity was not confirmed on the behavior of electrons.
We developed a lost alpha detection system to use in burning plasma experiments. The scintillators of Ag:ZnS and polycrystalline Ce:YAG were designed for a high-temperature environment, and the optical transmission line was designed to transmit from the scintillator to the port plug. The required optical components of lenses and mirrors were irradiated using the fission reactor with the initial result that there was no clear change after the irradiation with a neutron flux of for 48 h. We propose a diagnostic of alpha particle loss, so-called alpha particle induced gamma ray spectroscopy. The initial laboratory test has been carried out by the use of the Ce doped scintillator detector and an Am–Be source to detect the 4.44 MeV high energy gamma ray due to the reaction.
A novel method, called Advanced Multi-Step Brazing, was developed to fabricate a new type of divertor heat removal component with W armor and an oxide-dispersion-strengthened copper (GlidCop®) heat sink in the initial phase of our work. Later, a new type of divertor heat removal component, which has a rectangular-shaped cooling channel with a V-shaped staggered-rib structure in the GlidCop heat sink, was developed. This new component showed an extremely high heat removal capability during a ~30 MW/m2 steady-state heat loading condition in our previous work. In this work, the new component was installed in the divertor strike position of the Large Helical Device and exposed to neutral beam injection–heated plasma discharges with 1180 shots (~8000 s) in total. Though submillimeter-scale damage, such as unipolar arc trails and microscale cracks, was identified on the W surface, the extremely high heat removal capability did not show any sign of degradation over the experimental period. On the other hand, remarkable sputtering erosion and redeposition phenomena, due to the strong influx of the divertor plasma, was confirmed on the W armor.