Insulated-gate bipolar transistors (IGBTs) always operate in parallel for a large output current in modern high-power converter design. Suppressing dynamic current imbalance of the paralleled IGBTs is crucial for stable operation of converters. Though dynamic current imbalance could be suppressed by the symmetrical power loop design and consistent control signal, there is an inherent parameter difference in the power loop or gate circuit caused by the practical factors such as materials, physical dimensions and installation methods. The inherent difference could be compensated with gate delay control in a certain degree. The voltage and current in the key dynamic phases of IGBT are analyzed to obtain the delay compensation in gate delay control. An asynchronous gate signal driving method based on reference signal selections is proposed to suppress dynamic imbalance of collector current from parallel connected IGBTs, and the implementation of the asynchronous drive is described in brief. By using simulation software, the delay settings and dynamic current imbalance under different parameters discrepancy of drive circuit are obtained. The delay difference from key dynamic phases is calculated as the compensation for balanced dynamic current sharing under two selections of reference signals. Furthermore, the dynamic current distribution in the turn-on and turn-off phases is compensated by the asynchronous drive control. The optimization of asynchronous drive method on dynamic current sharing of paralleled IGBTs is verified by comparing dynamic current imbalance between the system with compensation and the system without compensation.
1 May 2021 in Journal of Physics: Conference Series
In the process of photovoltaic power generation, it is particularly important to choose a suitable inverter control strategy. Aiming at problems such as the poor dynamic response of the traditional controller in the three-phase LCL grid-connected inverter, the current harmonic disturbance caused by the grid voltage distortion and the inability to achieve the optimal tracking of the AC quantity, this paper presented a method to control voltage by fuzzy PI, control current by discrete QPR and improved DBC. In the voltage outer loop, the fuzzy control principle was used to adjust the P and I parameters in real time, and its output was used as the reference value for the current inner loop. In the current inner loop, the repeated control improved deadbeat and discretized form of QPR were used for compound control. The simulation results show that the control strategy greatly improves the distortion of the grid-connected current, which can optimally track the AC volume, and makes the entire system have good stability and dynamic response capabilities.