1 August 2024 in Physics of Plasmas
Interactions of floating potential on metal and dielectric targets with He atmospheric pressure plasma jet (APPJ) were studied in this paper. The APPJ is generated in a needle-ring corona-dielectric barrier discharge configuration, driven by a sinusoidal voltage. The characteristics of APPJ were assessed through electrical and optical examinations, and the time-average electrostatic voltage on the targets was measured using both contact and non-contact electrostatic voltmeters. It was found that both metal and dielectric targets can promote the jet development and speed up the jet velocity. During the negative half-cycle, the “plasma cluster” propagates from the target toward the ground electrode and then “merges” with the forward plasma jet, leading to a reversed development of jet. The two targets follow a similar pattern on the surface electrostatic voltage, that is, initially in a positive polarity whose amplitude first increases and then decreases and transits to negative polarity with an increase in the applied voltage. But there are also some minor differences between the two targets, e.g., the metallic target can change the discharge pattern and reduces the discharge current under certain conditions.
30 December 2019 in IEEE Access
In this paper, two iterative learning control methods are proposed for the different high-order systems with arbitrary initial shifts. The tracking errors caused by nonzero initial shifts are easily detected when applying conventional learning algorithms. But this defect is overcome through applying a step-by-step rectifying controller with initial initial rectifying action introduced in a small interval. It demonstrates the improvement of tracking performance and shows the robustness with respect to the stochastic initial shifts. Finally, simulation results are presented to illustrate the effectiveness of the stated algorithms.
13 January 2025 in IEEE Transactions on Instrumentation and Measurement
This paper develops an electrostatic device (ESD) tester with particularly high sensitivity for the charged device model (CDM) by incorporating empirical equivalent circuit (EC) parameters. The tester is implemented by using software and hardware system based on the STM32® microcontroller The tester feasibility study involves circuit theoretical analysis and simulation enabling to investigate the influence of EC parameters on the discharge signal waveform. High-precision and automated ESD sensitivity are utilized to develop the proposed testing system. As proof of concept, various common electronic components are tested. The performed experiment reveals that the CDM discharge signal is influenced not only by the DUT’s capacitance, but also by the packaging structure and pins for different functions. The explored measurement results highlight the importance of considering different pins for electronic device ESD protection neasures. The present study is industrially useful to enhance the ESD immunity during the design of electronic devices or chips by considering their circuit connections.