1 January 2018 in Advances in Materials Science and Engineering
In order to improve the inspection efficiency and accuracy of the braking capacity of the elevator brake being used, a novel method for analyzing the full‐loaded braking performance by using the unloaded braking performance is proposed, and a set of methods for measuring the braking torque is designed. Based on the analysis of the key factors that affect the mechanical performance of the elevator brake, the calculation model of the braking torque in the process of the emergency braking with the traction ratio of 2 : 1 is established, and the relationship between the braking torque and acceleration under different working conditions is analyzed. It is shown that, for the model assumed, the emergency braking torque is 1.56 times that of the static braking torque under 1.25 times the rated load. The braking torque increases linearly with the increase of braking acceleration. An elevator model being used is tested and calculated. The experimental results show that the braking acceleration measured by the experiment is 11.95% less than the theoretical value. And the analysis shows that, comparing with the traditional test method, the braking torque test method designed in this paper is more accurate and safe.
10 March 2021 in Advances in Mechanical Engineering
To improve the accuracy of braking distance measurement and reduce the impact of human factors on brake risk assessment of escalators, a non-contact braking distance measuring device based on infrared ranging principle is designed. Futher, a quantifiable risk assessment method of brake based on failure mode and effects analysis (FMEA) is propose in this paper. Characteristics and trends of distance changes during emergency braking process of the escalator are theoretically analyzed. To extract, process, and recognize the distance change signals, and finally to realize accurate measurement of the braking distance, a high-speed infrared distance measurement technology is used. Influencing factors of the escalator brake performance are studied. The risk analysis method based on FMEA is used to analyze its failure mode, failure mechanism, and consequences of the failure. A risk index assessment system is constructed and quantified. The test results show that the measurement error of the device designed is 1.6%, which is 1/6 of the traditional measurement method. The repeated measurement error of the device is 1.4%, which is 1/7 of the traditional measurement method. Application results show that the quantifiable risk assessment method quantifies and assigns the risk level according to the weight, which effectively avoids the inconsistent results caused by human bias. The evaluation results are more scientific and reliable.
2 September 2020 in Mathematical Problems in Engineering
In order to study the relationship between the braking distance and the load of escalator and realize the prediction of the rated load braking distance with a little load, the method of combining theoretical analysis and experimental research is used. First, the dynamic characteristics of the escalator during emergency braking are analyzed, and the prediction model of the braking distance of the escalator under different loads is derived based on the law of conservation of energy. Furthermore, the influence coefficients under different loads were determined through experimental studies, the model was revised, and the concept of equivalent no-load kinetic energy (ENKE) was proposed. The research shows that the braking distance of the escalator increases nonlinearly with the increase in load. When the no-load braking distance and the 25% rated load braking distance change greatly, the braking distance increases faster as the load increases; the escalators with large brake force have a small ENKE and are easy to stop. Otherwise, it is difficult to stop. The test results show that the comparison between the predicted value of the prediction model and the measured value has a maximum error of 2.7%, and the maximum error at rated load is only 2.0%, which fully meets the needs of engineering measurement. And the prediction method reduces test costs, enhances test security, and improves test coverage.