6 June 2024 in Composites Science and Technology
25 September 2021 in Nano
11 May 2026 in IEEE Transactions on Dielectrics and Electrical Insulation
The SiC/epoxy nonlinear conductive coating has shown great potential in DC GIS/GIL for its ability to suppress surface charge accumulation and homogenize the electric field. However, a high doping amount severely restricts its further application. In this paper, an in-situ electric field-assisted technology is introduced to fabricate epoxy-based composite coatings with aligned SiC fillers. In-situ microscopic observation and micro computed tomography (Micro-CT) characterizations reveal the 3D orientation of the coatings. A comparison with uniformly doped samples at a higher concentration shows that the oriented coatings at a lower concentration have more continuous conductive paths, facilitating carrier migration. As a result, compared with uniformly doped coatings, the oriented coatings exhibit significantly lower trap levels and higher shallow trap densities. Moreover, combining experimental and simulation results reveals that increasing the in-situ electric field amplitude can significantly enhance the permittivity and DC nonlinear conductivity in the orientation direction. This increase alleviates local electric field distortion and improves the DC flashover voltage of the samples. This technology is more effective than simply increasing the doping amount, showing great potential in the insulation design of high-voltage DC devices.
3 October 2025 in IEEE Transactions on Dielectrics and Electrical Insulation
The temperature gradient significantly affects the surface charge accumulation on disc-type insulators in HVDC GIS/GIL. In this paper, the surface charge accumulation characteristics under various temperature gradients are tested, and a simulation model about electro-thermal coupling is established to provide the theoretical analysis. Experimental results show that the average homo-charge density decreases from 3.79 μC/m2 to 1.57 μC/m2 as temperature gradient increases, which is attributed that the dominant pathway of homo-charge accumulation transfers from surface to bulk conduction. In contrast, the average hetero-charge density increases from 0.98 μC/m2 to 4.82 μC/m2. This is because large temperature gradients cause the electric field near grounded electrode significantly increasing from 1.05 kV/mm to 2.78 kV/mm, thereby massive hetero-charges from the grounded electrode migrate to the nearby insulator surface. This work can provide valuable references for the insulation design of disc-type insulators in DC GIS/GIL.
25 September 2025 in IEEE Transactions on Dielectrics and Electrical Insulation
The temperature gradient is a crucial factor affecting the flashover characteristics at the gas-solid interface in DC GIS/GIL. This paper proposes a “stepwise approximation” method and utilizes it to measure the charge distribution approaching flashover occurrence (CDAFO). The electric field distribution considering CDAFO is calculated to analyze the effect of surface charge on DC flashover voltage at temperature gradients. The results show that with increasing temperature gradient, both positive and negative flashover voltages gradually decrease. The hetero-charge accumulation increases significantly, with high-density hetero-charge clusters appearing at the moment approaching flashover. These charge clusters greatly enhance the electric field near high-voltage electrode: the maximum electric field under negative voltage increases from 3.64 kV/mm to 4.96 kV/mm, and it increases from 3.45 kV/mm to 5.09 kV/mm under positive voltage. This electric field enhancement leads to the reduction in flashover voltage. This work can provide valuable references for the insulation design of DC GIS/GIL systems under temperature gradients.