13 May 2003 in IEEE Transactions on Power Electronics
New recommendations and future standards have increased the interest in power factor correction circuits. There are multiple solutions in which line current is sinusoidal. In addition, a great number of circuits have been proposed with nonsinusoidal line current. In this paper, a review of the most interesting solutions for single phase and low power applications is carried out. They are classified attending to the line current waveform, energy processing, number of switches, control loops, etc. The major advantages and disadvantages are highlighted and the field of application is found.
8 May 2006 in IEEE Transactions on Power Electronics
Interleaving technique is used in some applications due to its advantages regarding filter reduction, dynamic response, and power management. In dual battery system vehicles, the bidirectional dc-dc converter takes advantage of this technique using three-to-five paralleled buck stages. In this paper, we propose the use of a much higher number of phases in parallel together with digital control. It will be shown that this approach opens new possibilities since changes in the technology are possible. Thus, two 1000-W prototypes have been designed using surface mount technology devices (SO-8 transistors). An additional important feature is that due to the accuracy of the digital device [field-programmable gate array (FPGA)], current loops have been eliminated, greatly simplifying the implementation of the control stage
20 March 2003 in IEEE Transactions on Power Electronics
Nowadays, most digital controls for power converters are based on DSPs. This paper presents a field programmable gate array (FPGA) based digital control for a power factor correction (PFC) flyback AC/DC converter. The main difference from DSP-based solutions is that FPGAs allow concurrent operation (simultaneous execution of all control procedures), enabling high performance and novel control methods. The control algorithm has been developed using a hardware description language (VHDL), which provides great flexibility and technology independence. The controller has been designed as simple as possible while maintaining good accuracy and dynamic response. Simulations and experimental results show the feasibility of the method, opening interesting possibilities in power converters control.
1 February 2014 in IEEE Transactions on Power Electronics
The combination of minimum time control and multiphase converter is a favorable option for dc-dc converters in applications where output voltage variation is required, such as RF amplifiers and dynamic voltage scaling in microprocessors, due to their advantage of fast dynamic response. In this paper, an improved minimum time control approach for multiphase buck converter that is based on charge balance technique, aiming at fast output voltage transition is presented. Compared with the traditional method, the proposed control takes into account the phase delay and current ripple in each phase. Therefore, by investigating the behavior of multiphase converter during voltage transition, it resolves the problem of current unbalance after the transient, which can lead to long settling time of the output voltage. The restriction of this control is that the output voltage that the converter can provide is related to the number of the phases, because only the duty cycles at which the multiphase converter has total ripple cancellation are used in this approach. The model of the proposed control is introduced, and the design constraints of the buck converter's filter for this control are discussed. In order to prove the concept, a four-phase buck converter is implemented and the experimental results that validate the proposed control method are presented. The application of this control to RF envelope tracking is also presented in this paper.