Shupeng Li

Shupeng Li

Auto-generated profile, based on publicly available information

Shupeng Li

Key Laboratory of Radar Imaging and Microwave Photonics, Ministry of Education, Nanjing University of Aeronautics and Astronautics, Nanjing, China

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 November 2019 in Nature Communications
Verified
Journal Article
Open access
TQTing Qing
Ting Qing
SLShupeng Li
Shupeng Li
zhenzhou tangzhenzhou tang
zhenzhou tang
BGBindong Gao
Bindong Gao
SPShilong Pan
Shilong Pan
Optical vector analysis (OVA) capable of achieving magnitude and phase responses is essential for the fabrication and application of emerging optical devices. Conventional OVA often has to make compromises among resolution, dynamic range, and bandwidth. Here we show an original method to meet the measurement requirements for ultra-wide bandwidth, ultra-high resolution, and ultra-large dynamic range simultaneously, based on an asymmetric optical probe signal generator (ASG) and receiver (ASR). The ASG and ASR remove the measurement errors introduced by the modulation nonlinearity and enable an ultra-large dynamic range. Thanks to the wavelength-independence of the ASG and ASR, the measurement range can increase by 2 N times by applying an N-tone optical frequency comb without complicated operation. In an experiment, OVA with a resolution of 334 Hz (2.67 attometer in the 1550-nm band), a dynamic range of > 90 dB and a measurement range of 1.075 THz is demonstrated.

10 August 2020 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
SLShupeng Li
Shupeng Li
TQTing Qing
Ting Qing
JFJianbin Fu
Jianbin Fu
XWXiangchuan Wang
Xiangchuan Wang
SPShilong Pan
Shilong Pan
Measurement of optical transfer delay (OTD) is crucial to applications such as fiber-distributed multi-antenna systems, fiber-optic sensors, and high-capacity optical fiber communications. However, present OTD measurement techniques are inadequate for the demands of high accuracy, high speed, and large measurement range, simultaneously. Here, we propose a novel method based on nonlinear frequency sweeping and phase derived ranging to achieve all the above performance. A continuous-wave light modulated by a microwave signal propagates in a device under test. Then, the OTD is mapped into the phase variation of the microwave signal by photo-detection. A microwave phase discriminator is used to extract the phase variation from the microwave signal, while the nonlinear frequency sweeping and a novel phase unwrapping algorithm are proposed to resolve 2π phase ambiguity caused by phase detection. Frequencies of the microwave swept signals are set at four selected points in a range of 10 MHz, which ensures high speed and large measurement range. Our experiment results verify an accuracy of ±0.05 ps in measuring an ultrahigh-accuracy optical delay line. In addition, long fiber is also tested, which proves that a measurement range of at least 37 km (theoretically 100 km) can be achieved. Moreover, the measurement speed reaches milliseconds per measurement.

3 July 2019 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
SLShupeng Li
Shupeng Li
XWXiangchuan Wang
Xiangchuan Wang
TQTing Qing
Ting Qing
SLShifeng Liu
Shifeng Liu
JFJianbin Fu
Jianbin Fu
SPShilong Pan
Shilong Pan
High accuracy optical fiber transfer delay (OFTD) measurement with a broad measurement range is essential for the development of high-speed or parallel optical devices and systems. In this work, we propose a system for OFTD measurement using phase-derived ranging. A microwave signal is converted into an optical signal, which is transmitted through a fiber under test. After photodetection, the OFTD is converted into the phase shift of the microwave signal, which can be detected using a microwave phase detector. When calculating the OFTD, the phase error is divided by the highest microwave frequency, which ensures high measurement accuracy. The integer ambiguity caused by phase detection can be removed by sweeping the microwave frequency in a range of 1 MHz. An experiment is performed. The measurement of a motorized variable optical delay line and a long fiber shows that a dynamic range of more than 20 kilometers and an accuracy of ±0.1 picoseconds can be achieved with no dead zone.

26 June 2019 in Optics Letters
Verified
Journal Article
Closed access
PDF file
SLShupeng Li
Shupeng Li
MXMin Xue
Min Xue
TQTing Qing
Ting Qing
Changyuan YUChangyuan YU
Changyuan YU
LWLugang Wu
Lugang Wu
SPShilong Pan
Shilong Pan
We propose and experimentally demonstrate an ultrafast and ultrahigh-resolution optical vector analyzer (OVA) using linearly frequency-modulated (LFM) waveform and dechirp processing. An optical LFM signal, achieved by modulating an electrical LFM signal on an optical carrier via carrier-suppressed optical single-sideband (OSSB) modulation, is separated into two portions. One portion (denoted as the reference signal) directly goes through the reference path, and the other (denoted as the probe signal) undergoes magnitude and phase changes by an optical device under test (DUT) in the measurement path. After balanced photodetection, the reference signal and the probe signal are mixed to perform a dechirp operation. A relatively low-frequency electrical signal is generated, which can be sampled by a low-speed analog-to-digital converter. As a result, the frequency responses of the DUT can be extracted at a high speed by post digital signal processing. Thanks to the large chirp rate of the electrical LFM signal and the dechirp processing, the proposed LFM-based OVA enables ultrafast measurement speed and ultrahigh frequency resolution. We perform an experiment in which a narrowband tunable optical filter is characterized. The measurement speed reaches 1 ns/point, and the frequency resolution is 1.6 MHz.

23 October 2020 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
SLShupeng Li
Shupeng Li
TQTing Qing
Ting Qing
JFJianbin Fu
Jianbin Fu
XWXiangchuan Wang
Xiangchuan Wang
SPShilong Pan
Shilong Pan
Optical fiber transfer delay (OFTD) measurement with high accuracy and stability is an urgent demand for many applications such as fiber-optic sensors and fiber-based distributed systems. In this article, we propose a novel method using fiber-optic microwave interferometry to meet the above practice demand. Two incoherent optical carriers with different wavelengths are coupled into an intensity modulator driven by a microwave signal. The intensity-modulated signal is then divided into two portions through a dense wavelength division multiplexer. One portion directly passes through the reference path while the other undergoes the transfer delay of a fiber under test (FUT). After photo-detection, two probe signals that undergo different delays are recovered and superimposed. By sweeping the microwave frequency, periodic microwave interference fringe is generated. Then, OFTD measurement is achieved by measuring the frequency of the last valley in the interference fringe. Experimental results show that a system stability of ±0.02 ps, an accuracy of ±0.07 ps, and a measurement range of at least 500 m are achieved.

5 May 2021 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
TQTing Qing
Ting Qing
SLShupeng Li
Shupeng Li
YFYijie Fang
Yijie Fang
LWLihan Wang
Lihan Wang
XTXiaohu Tang
Xiaohu Tang
SPShilong Pan
Shilong Pan
High-resolution and high-sensitivity optical vector analysis (OVA) is highly desired by many applications, such as optical sensors and photonic integrated circuits (PICs). However, it is difficult to achieve high resolution and high sensitivity simultaneously. Here, we propose and experimentally demonstrate a high sensitivity OVA using coherent detection to achieve the complex frequency responses (including magnitude and phase responses) of a device under test (DUT). Carrier phase noise (CPN) cancellation is employed to eliminate the carrier phase fluctuation induced by the coherent detection. In an experiment, the frequency responses of a fiber Bragg grating (FBG) is accurately measured by the proposed method when the probe light is suppressed by ~18 dB. As a comparison, the method using coherent detection without CPN cancellation can only achieve the magnitude response, and the method using direct detection cannot obtain an effective measurement. The influence of the linewidth and time delay on the measurement is discussed. The proposed OVA provides a stable, high resolution, high sensitivity and low cost approach for characterizing optical devices with arbitrary response, especially for optical devices with large loss or bandpass response.