In general, the power quality analysis is a very complex issue and it requires a long-term measurement in real distribution networks. Moreover, the voltage has to be within specific voltage tolerance for the low-voltage distribution network. In this paper the measurement of the low-voltage network after the connection of a small photovoltaic power plant is evaluated. Therefore, the influence on the changes of the voltage, flicker and total harmonic distortion by connected power plant under different operating states is described in the paper. The main task of the article is to present the results of the voltage quality measurements carried out in low-voltage distribution network.
The paper deals with an optimization procedure in terms of a network voltage parameters improvement. A software based approach is used to select optimal type of voltage regulator, its power and ideal location for application in a Low-Voltage (LV) test network, where it is required to enhance Voltage Quality (VQ). The test network presents a case where application of on-load tap changer transformer instead of conventional distribution transformer MV/LV is not adequate to maintain voltage profile in the LV system in limits. Therefore other type of voltage regulator has to be employed to increase VQ in the entire LV network. Principal measure for VQ evaluation there is adopted a Voltage Quality Index expressing the VQ level in dependence on selected and specified input parameters, which may be voltage magnitude, unbalance, harmonic distortion, flicker level and frequency. Within optimization process, maximal current carrying capacity of lines, network losses and cost of solutions are also taken into account.
The paper focuses on the creation of a mathematical model of a small wind power plant with a vertical axis of rotation with a Savonius-Darrieus rotor within the PSCAD. The paper describes the principle of a wind energy source and it brings basic data about this technology and specifies individual parameters and their mutual relations that are needed for mathematical simulation. The paper also presents the results of simulations of the created mathematical model and assesses the overall generated energy for an average and above-the-average windy day in a chosen area.