Current problems of filamentous fungi fermentations and their further successful developments as microbial cell factories are dependent on control fungal morphology. In this connection, this work explored new experimental procedures in order to quantitatively check the potential of some culture conditions to induce a determined fungal morphology by altering both hyphal morphology and conidia adhesion capacity. The capacity of environmental conditions to modify hyphal morphology was evaluated by examining the influence of some culture conditions on the cell wall lytic potential ofAspergillus nigerMYA 135. The relative value of the cell wall lytic potential was determined by measuring a cell wall lytic enzyme activity such as the mycelium-bound β-N-acetyl-D-glucosaminidase (Mb-NAGase). On the other hand, the quantitative value of conidia adhesion was considered as an index of its aggregation capacity. Concerning microscopic morphology, a highly negative correlation between the hyphal growth unit length (lHGU) and the specific Mb-NAGase activity was found (r = -0.915, P < 0.001). In fact, the environment was able to induce highly branched mycelia only under those culture conditions compatible with specific Mb-NAGase values equal to or higher than 190 U gdry.wt-1. Concerning macroscopic morphology, a low conidia adhesion capacity was followed by a dispersed mycelial growth. In fact, this study showed that conidia adhesion units per ml equal to or higher than 0.50 were necessary to afford pellets formation. In addition, it was also observed that once the pellet was formed the lHGUhad an important influence on its final diameter. Finally, the biotechnological significance of such results was discussed as well.
27 June 2007 in Applied Microbiology and Biotechnology
The impact of biomass morphology and culture conditions on fungal fermentation was widely reviewed in the literature. In this work, we presented three independent experiments in order to evaluate the influence of some of those input factors on a lipase production separately by using the Aspergillus niger MYA 135 and the two-stage fermentation technique. Regarding the culture modality, the biomass was pre-grown in a first reactor. Then, the washed mycelium was transferred to a second reactor to continue the study. Firstly, linear effects of fungal morphology and several physiological parameters on a lipase production were explored using the Plackett–Burman design. The dispersed fungal morphology was confirmed as a proper quality characteristic for producing an extracellular lipase activity. Concerning the impact of the carbon source on the biomass pre-growth, the sucrose (E = 9.923, p < 0.001) and the l-arabinose (E = 4.198, p = 0.009) presented positive and significant effects on the enzyme production. On the contrary, the supplementation of 0.05 g/L CaCl2 displayed a highly negative and significant effect on this process (E = − 7.390, p < 0.001). Secondly, the relationship between the enzyme production and the input variables N:C ratio, FeCl3 and olive oil was explored applying the central composite design. Among the model terms, the N:C ratio of the production medium had the most negative and significant influence on the enzyme synthesis. Thus, it was concluded that a low N:C ratio was preferable to increase its production. In addition, the bifunctional role of FeCl3 on this fungus was presented. Thirdly, a prove of concept assay was also discussed.
Spray products based on Bacillus thuringiensis (Bt) (Berliner) (Bacillales: Bacillaceae) are widely used as control agents of the fall armyworm, Spodoptera frugiperda (J.E. Smith) (Lepidoptera: Noctuidae), in some major crops such as corn, cotton, and soy. However, there is little information about the toxicity of Bt formulations to control corn and rice-infesting S. frugiperda strains. These S. frugiperda strains are morphologically indistinguishable, so they are genetically identified as corn and rice S. frugiperda strains. The main objective of this study was to evaluate the susceptibility of third instar larvae of both S. frugiperda biotypes to either the native Bt RT or the reference Bt HD1 subsp. kurstaki (Btk) formulations. In addition, the S. frugiperda populations were characterized by their esterase profile in polyacrylamide gels. This study also allowed differentiation of the S. frugiperda strains. Concerning the susceptibility assays, a significant difference in mortality values was found within some corn or rice S. frugiperda colonies when Bt RT treatment was used, whereas there were no significant differences in Btk HD1 toxicity within colonies that share the same biotype. When toxicity of either the native Bt RT or the reference Btk HD1 to each S. frugiperda biotype was compared, significant differences in mortality values also were found in the corn and the rice S. frugiperda strains. Finally, the statistical analysis of the mortality data revealed that there was a significant difference between the 2 S. frugiperda strains, regardless of the Bt preparation. These results show that the S. frugiperda control could depend not only on the bioinsecticide used, but also on the S. frugiperda biotype being treated.
SO2 is traditionally used to limit or nullify the proliferation of spoilage yeasts in must/wine, but its use has become controversial due to its negative effects on human health. An alternative strategy for the control of spoilage yeasts is the use of biocontrol yeasts. Wickerhamomyces anomalus is an outstanding biocontroller yeast that has been examined by our group and that is a good biocontrol agent against Brettanomyces bruxellensis and Zygosaccharomyces rouxii. The challenge regarding the application of the results of microbial biocontrol studies lies in exploring technologically simple and economical ways to make use of microbial biocontrol activity. The introduction of foreign microbiota adds complexity to the fermentation medium and can cause technological difficulties and have oenological consequences inherent to the implementation of mixed cultures. Therefore, the objective of this study was to characterise the concentrated culture supernatant of W. anomalus and evaluate its biocontrol action in liquid medium on two main wine spoilage yeasts. W. anomalus BWa156 supernatant demonstrated inhibitory killer protein characteristics. The production of the inhibitory supernatant by the biocontroller yeast was independent of the presence or absence of the spoilage yeast. Supernatant can be produced faster under aerobic conditions than in traditional fermentation (i.e., with around 24 h), thus increasing its potential for technological development. The treatment with the supernatant of BWa156 was effective against the two spoilage populations Zygosaccharomyces rouxii and Brettanomyces bruxellensis, which are considered problematic for the wine industry. The supernatant of the biocontrol yeast can be considered to be a relevant additional stress factor for the spoilage population, which together with other factors such as ethanol, competition for nutrients, oxygen and pH, contributes to the elimination of the polluting population. This technology would allow a simple future application, through its production in a bioreactor parallel to the fermentation and subsequent inoculation in the must/wine.
6 October 2014 in Chemical Engineering & Technology