1 January 2011 in Forest Products Journal
Hemicellulose is the most hydrophilic polymer of wood, and as a polysaccharide, it has potential applications in conversion to biofuels. The objective of this study was to enhance properties of flakeboard by extracting hemicellulose. Hot-water pretreatment was performed to extract hemicellulose under different temperatures (140°C, 155°C, and 170°C) and times (30 and 60 min). The flakes were blended with 5 percent liquid phenol-formaldehyde resin and 1 percent wax emulsion. The mat was pressed at 200°C for 5 minutes. The physical and mechanical properties and the susceptibility of flakeboard to mold were studied. Panels made from the hemicellulose-extracted flakes showed remarkable decreases in water absorption and thickness swelling without a decrease in mechanical properties. Resistance of the panels to the mold growth also increased with increasing mass loss due to extraction. The most severe condition of extraction (170°C, 60 min), in addition to having the lowest water absorption and thickness swelling, showed the highest mold resistance.
3 December 2019 in Frontiers in Energy Research
Editorial: Advancements in Biomass Feedstock Preprocessing: Conversion Ready Feedstocks
1 April 2007 in Journal of Materials in Civil Engineering
Near-infrared (NIR) spectroscopy was used to predict the longitudinal tensile modulus, the longitudinal tensile strength, and the creosote content of wood from an out-of-service southern pine utility pole. Tensile samples were cut from the pole in the radial direction and near-infrared spectra were obtained before testing. Coefficients of determination , of 0.80–0.86 were obtained between the NIR spectra predicted modulus and measured modulus. Coefficients of determination for strength were lower, 0.58–0.63. After tensile testing, the specimens were ground in a mill and spectra were obtained from the homogeneous ground samples. There was a slight decrease in the coefficients of determination using the ground samples, 0.76–0.82 for the modulus and 0.46–0.57 for the strength. Creosote content was difficult to predict with the NIR spectra of the whole sample, but coefficients of determination were obtained with the ground samples. There was little difference in the results for spectra collected over the range and those obtained with just looking at the range. This suggests that it will be feasible to predict the mechanical properties of treated timber using lightweight, relatively inexpensive, portable instruments rather than larger, more expensive systems that cover the entire NIR range.
30 July 2014 in BioEnergy Research
The 2012 Sun Grant National Conference on Science for Biomass Feedstock Production and Utilization was held on 2–5 October 2012, in New Orleans, LA, USA. The Sun Grant Initiative set out to highlight recent advances in science and technology contributing to the deployment of conventional and advanced biofuels and bioproducts from agricultural and forest systems. The Initiative, with sponsorship from the Department of Energy’s Bioenergy Technologies Office (BETO), assembled an agenda focusing on promoting collaboration between academic, industry, non-profit, and government partners. This special issue is comprised of a small sample of conference presentations selected to reflect important research progress and to highlight the range of issues that must be considered as the transition to biomass energy takes hold.