Lignin/lignin blends were used to improve fiber spinning, stabilization rates, and properties of lignin-based carbon fibers. Organosolv lignin from Alamo switchgrass (Panicum virgatum) and yellow poplar (Liriodendron tulipifera) were used as blends for making lignin-based carbon fibers. Different ratios of yellow poplar:switchgrass lignin blends were prepared (50:50, 75:25, and 85:15 w/w). Chemical composition and thermal properties of lignin samples were determined. Thermal properties of lignins were analyzed using thermogravimetric analysis and differential scanning calorimetry. Thermal analysis confirmed switchgrass and yellow poplar lignin form miscible blends, as a single glass transition was observed. Lignin fibers were produced via melt-spinning by twin-screw extrusion. Lignin fibers were thermostabilized at different rates and subsequently carbonized. Spinnability of switchgrass lignin markedly improved by blending with yellow poplar lignin. On the other hand, switchgrass lignin significantly improved thermostabilization performance of yellow poplar fibers, preventing fusion of fibers during fast stabilization and improving mechanical properties of fibers. These results suggest a route towards a 100% renewable carbon fiber with significant decrease in production time and improved mechanical performance.
1 December 2016 in Composites Science and Technology
Hemicellulose is the most hydrophilic polymer of wood, and as a polysaccharide, it has potential applications in conversion to biofuels. The objective of this study was to enhance properties of flakeboard by extracting hemicellulose. Hot-water pretreatment was performed to extract hemicellulose under different temperatures (140°C, 155°C, and 170°C) and times (30 and 60 min). The flakes were blended with 5 percent liquid phenol-formaldehyde resin and 1 percent wax emulsion. The mat was pressed at 200°C for 5 minutes. The physical and mechanical properties and the susceptibility of flakeboard to mold were studied. Panels made from the hemicellulose-extracted flakes showed remarkable decreases in water absorption and thickness swelling without a decrease in mechanical properties. Resistance of the panels to the mold growth also increased with increasing mass loss due to extraction. The most severe condition of extraction (170°C, 60 min), in addition to having the lowest water absorption and thickness swelling, showed the highest mold resistance.
26 June 2017 in Journal of Coatings Technology and Research