Dong Ji

Dong Ji

Auto-generated profile, based on publicly available information

Dong Ji

Department of Electrical and Computer Engineering, University of California at Davis, Davis, CA, USA

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 December 2016 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
DJDong Ji
Dong Ji
MLMatthew A. Laurent
Matthew A. Laurent
AAAnchal Agarwal
Anchal Agarwal
WLWenwen Li
Wenwen Li
SMSaptarshi Mandal
Saptarshi Mandal
SCSrabanti Chowdhury
Srabanti Chowdhury
A normally OFF trench current aperture vertical electron transistor (CAVET) was designed and successfully fabricated with Mg-doped p-GaN current blocking layers. The buried Mg-doped GaN was activated using a postregrowth annealing process. The source-to-drain body diode showed an excellent p-n junction characteristics, blocking over 1 kV, sustaining a maximum blocking electric field of 3.8 MV/cm. Three-terminal breakdown voltages of trench-CAVETs, measured up to 225 V, were limited by dielectric breakdown. This paper highlights the achievement of the well-behaved buried p-n junction that has been a formidable challenge in the success of vertical GaN devices.

20 April 2018 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
DJDong Ji
Dong Ji
AAAnchal Agarwal
Anchal Agarwal
HLHaoran Li
Haoran Li
WLWenwen Li
Wenwen Li
SKStacia Keller
Stacia Keller
SCSrabanti Chowdhury
Srabanti Chowdhury
In this letter, we report a high-voltage metal-insulator-semiconductor (MIS) gate trench CAVET using MOCVD regrown AlGaN/GaN as the channel and in-situ Si3N4 as the gate dielectric. The device had a high breakdown voltage of 880 V and a low Ron,sp of 2.7 mΩ·cm2. A low hysteresis of ~ 0.1 V was observed due to the high quality of the in-situ Si3N4.

8 March 2018 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
DJDong Ji
Dong Ji
CGChirag Gupta
Chirag Gupta
AAAnchal Agarwal
Anchal Agarwal
SCSilvia H. Chan
Silvia H. Chan
CLCory Lund
Cory Lund
SCSrabanti Chowdhury
Srabanti Chowdhury
We present a large area in-situ oxide, GaN interlayer based vertical trench MOSFET (OG-FET) with an MOCVD regrown 10 nm UID-GaN interlayer as the channel and 50 nm in-situ Al2O3 as the gate dielectric. The threshold voltage of the device on bulk GaN substrate was 1 V measured at Ion/Ioff = 107. The OG-FET with an area scaled to 0.2 mm2 demonstrated a breakdown voltage (VBR) of 320 V and an on-state resistance (Ron)of 3.8 Ω(specific on-state resistance: Ron,sp= 7.6 mΩ∙cm2). For the single unit cell OG-FET from the same sample, VBR was as high as 700 V (measured at VGS = -10V), corresponding to a breakdown electric field of 1.4 MV/cm, and Ron,sp of 0.98 mΩ∙cm2. On our control sample was grown on sapphire substrate, a 1 A current was measured as well. These results show the potential of the OG-FET in power conversion applications.

22 August 2018 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
DJDong Ji
Dong Ji
WLWenwen Li
Wenwen Li
SCSrabanti Chowdhury
Srabanti Chowdhury
This paper presents a comparison of switching performances between the in-situ oxide, gallium nitride (GaN) interlayer FET (OG-FET) and the conventional GaN metal-oxide-semiconductor FET (MOSFET), and explores the influence of the channel electron mobility on the device switching performance. GaN OG-FET is a novel structure with a pristine GaN layer grown between the gate oxide and the p-GaN enhancing the channel mobility up to 185 cm 2 /V· s, which is over 3× larger than that of the typical reported value (50 cm 2 /V · s) in GaN MOSFET. Owing to the high channel electron mobility, the GaN OG-FET showed a switching loss 30% lower than that of the conventional GaN trench MOSFET. Our results indicate that GaN OG-FET has the potential to attain greater efficiency, particularly at higher frequencies, showing a possible patch toward megahertz range conversions.

30 May 2017 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
SMSaptarshi Mandal
Saptarshi Mandal
AAAnchal Agarwal
Anchal Agarwal
EAElaheh Ahmadi
Elaheh Ahmadi
KBK. Mahadeva Bhat
K. Mahadeva Bhat
DJDong Ji
Dong Ji
SCSrabanti Chowdhury
Srabanti Chowdhury
In this letter, a GaN-based current aperture vertical electron transistor (CAVET) with a p-type gate layer and an implantation-based current blocking structure is presented. The devices measured showed a breakdown voltage of 450 V and no dispersion. The factors limiting higher breakdown voltages in these devices were carefully studied and discussed. The devices were grown on sapphire and relied on a box-shaped Mg implanted current blocking scheme. This is the first demonstration of an implantation-based CAVET, grown on sapphire blocking of 450 V with respectable on-state characteristics.

4 June 2018 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
DJDong Ji
Dong Ji
WLWenwen Li
Wenwen Li
AAAnchal Agarwal
Anchal Agarwal
SCSilvia H. Chan
Silvia H. Chan
JHJeffrey Haller
Jeffrey Haller
SCSrabanti Chowdhury
Srabanti Chowdhury
This letter reports on the dynamic $R_{\text{ON}}$ performance of large-area GaN vertical trench MOSFETs (OG-FETs) fabricated on bulk GaN substrates. OG-FETs demonstrated excellent DC performance with a breakdown voltage of 900 V and a $R_{\text{ON}}$ of 4.1 $\Omega$ (8.2 $\text{m}\Omega \cdot \text {cm}^{2}$ ). However, damage to the trench sidewalls caused by RIE dry etching led to poor dynamic $R_{\text{ON}}$ performance. An improved dynamic $R_{\text{ON}}$ performance was achieved by following the RIE dry etch with a TMAH wet etch. With this process combination, the dynamic $R_{\text{ON}}$ was reduced by more than 10 times compared with the dynamic $R_{\text{ON}}$ in devices fabricated by dry etch only.