Department Chemical Surface and Battery Technology Fraunhofer Institute for Material and Beam Technology (IWS) Winterbergstraße 28 01277 Dresden Germany
Auto-generated profile, based on publicly available information
Maria Rosner
Department Chemical Surface and Battery Technology Fraunhofer Institute for Material and Beam Technology (IWS) Winterbergstraße 28 01277 Dresden Germany
All‐solid‐state batteries (SSB) show great promise for the advancement of high‐energy batteries. To maximize the energy density, a key research interest lies in the development of ultrathin and highly conductive solid electrolyte (SE) layers. In this work, thin and flexible sulfide solid electrolyte membranes are fabricated and laminated onto a non‐woven fabric using a scalable and solvent‐free, continuous roll‐to‐roll process (DRYtraec). These membranes show significantly improved tensile strength compared to unsupported sheets, which facilitates cell assembly and allows a continuous component production using a single‐step calendering process. By tuning the thickness, densified membranes with thicknesses ranging from 40 to 160 µm are obtained after a compression step. The resulting SE membranes retain a high ionic conductivity (1.6 mS cm−1) at room temperature. An excellent rate capability is demonstrated in a SSB pouch cell with a Li2O–ZrO2‐coated LiNi0.9C0.05Mn0.05O2 cathode, a 55 µm thin SE membrane, and a columnar silicon anode fabricated by a scalable physical vapor deposition process. At stack level, a promising energy density of 673 Wh L−1 (and specific energy of 247 Wh kg−1) is achieved, showcasing the potential for high energy densities by reducing the SE membrane thickness while retaining good mechanical properties.
The solvent‐free processing of cell components is attracting growing interest, as it avoids energy‐intensive drying and solvent recovery procedures. In solid‐state batteries, the dry processing of solid electrolyte (SE) films results in improved ionic conductivities compared to wet processing and eliminates degradation due to residual solvent traces. For dry processing, the binder polytetrafluoroethylene (PTFE) is widely used due to its excellent fibrillation, but it shows poor electrochemical stability at low anode potentials. Here, the influence of processing parameters on the binder structure is evaluated, and the electrochemical degradation of the dry film separators is systematically investigated (e.g., CTTA measurements) at different anode potentials (Si and Li anode). A combination of electrochemical and surface characterization at the SE dry film/anode interface is conducted. The results confirm that processing has a large influence on the stability at the dry film/anode interface. By adapting the SE dry film processing, long‐term cycling in Si||NMC pouch cells is demonstrated over more than 1300 cycles. Additionally, a high initial coulombic efficiency of 92% and an average CE of 99.7% are obtained over 100 cycles, highlighting the potential of dry film separators for the application with Si anodes.