This article describes a dual-polarized end-fire antenna array for millimeter-wave frequencies. The antenna consists of a chain-slot-shaped pattern on a mobile phone metal frame. The antenna is fed using a transmission line, which would cause only a negligible capacitive loading of the sub- 6 GHz antenna realized on the same metal frame and, therefore, would not significantly degrade its perfomance. This makes colocating the sub-6GHz and mm-wave antennas in the same, shared volume possible. Measurements indicate that a 4-element array placed within a mobile phone provides a realized gain between 8 and 12.6 dBi for both polarizations across the entire band from 24.5 to 29.5 GHz. The total efficiency of a single element is better than -2 and -3 dB for the whole band for horizontal and vertical polarizations, respectively.
1 January 2018 in Progress in Electromagnetics Research C
The co-existence of millimeter-wave (mm-wave) and sub-6 GHz antennas in a smartphone presents many performance-limiting aspects. When both antennas are attached to the metal frame, the feed lines of the mm-wave antennas might short-circuit the sub-6 GHz antennas, and thus, may significantly affect their performance. This paper presents a method to design feed lines that function as transmission lines at mm-wave frequencies but correspond to open circuits at sub-6 GHz. This study determines, in theory, the smallest achievable capacitive loading with different line types and experimentally validates the approach. The capacitive loading due to the feed line is small enough to maintain the sub-6 GHz performance. At the mm-wave band, the insertion loss of the line is 1 dB with a measured reflection coefficient below –10 dB. The introduced common-mode capacitive load of the feed line on the sub-6 GHz antennas corresponds to 0.19 pF capacitance.
Antenna is one of the most important single part of a wireless communications system and significantly affects the total energy consumption. Current mobile antennas can be inefficient in both converting radio energy to radiating waves and also focusing the radiated waves. The upcoming 5G introduces additional challenges to antennas but could also provide opportunities to use RF energy more efficiently. This paper discusses 5G antenna challenges and presents two potential antenna solutions for 5G mobile devices and one for mm-wave access points.
Beam-steerable millimeter-wave antennas may enable more efficient use of RF energy in line-of-sight propagation paths than the currently used antennas at microwave frequencies. This paper discusses the challenges related to millimeter-wave antennas for mobile devices and networks and reviews possible approaches for realizing beam-steerable antennas for both applications. The presented millimeter-wave mobile device antenna can use shared volume with the microwave antennas without significantly affecting their performance. The presented antenna for mobile networks makes it possible to integrate active electronics on a single PCB with low-loss waveguide feed network and antenna arrays.