20 May 2019 in Nature Communications
Colloidal gels formed by arrested phase separation are found widely in agriculture, biotechnology, and advanced manufacturing; yet, the emergence of elasticity and the nature of the arrested state in these abundant materials remains unresolved. Here, the quantitative agreement between integrated experimental, computational, and graph theoretic approaches are used to understand the arrested state and the origins of the gel elastic response. The micro-structural source of elasticity is identified by the l-balanced graph partition of the gels into minimally interconnected clusters that act as rigid, load bearing units. The number density of cluster-cluster connections grows with increasing attraction, and explains the emergence of elasticity in the network through the classic Cauchy-Born theory. Clusters are amorphous and iso-static. The internal cluster concentration maps onto the known attractive glass line of sticky colloids at low attraction strengths and extends it to higher strengths and lower particle volume fractions.
22 September 2017 in Energy & Fuels
20 October 2023 in Langmuir
The formation of highly stable water-in-oil emulsions results in complications in both upstream and downstream processing. Emulsion stability in these systems has been connected to the adsorption of surface-active asphaltenes that are assumed to form a rigidified film at the oil/water (o/w) interface. Full characterization of this behavior is needed to allow for engineered solutions for enhanced oil recovery. Interfacial properties, such as surface pressure and interfacial elasticity, are implicated in the stabilizing mechanism for these observed films. Asphaltenes are known to be interfacially active in both good solvents (aromatics) and poor solvents (high ratio of aliphatic to aromatic). However, due to inherent complexities present in asphaltene studies, the details of the mechanical properties of the interface remain poorly understood. Despite the widely accepted perception that asphaltenes form persistent rigid films at fluid-fluid interfaces, the connection between bulk solution properties and interfacial mechanics has not been resolved. Here, the effects of solvent quality on the interfacial properties of asphaltene dispersions are determined by using a well-defined asphaltene/solvent system. Interfacial rigidity is observed only under poor solvent conditions, while the good solvent system remains fluid-like. The interfacial rheology under good and poor solvent conditions is measured simultaneously with surface pressure measurements to track interfacial development. It is shown that surface pressure and dilatational modulus measurements are not indicators of whether an interface demonstrates rigid behavior under large compressions. Finally, conditions required for asphaltene-coated interfaces to exhibit the mechanical behavior associated with a rigidified interface are defined. This work provides a framework for quantifying the impact of the aggregation state of asphaltenes on the stability and mechanics at the o/w interface.
26 January 2023 in Energy & Fuels