11 February 2022 in Journal of Power Sources
1 August 2019 in Applied Energy
7 January 2020 in Journal of the Electrochemical Society
The Lithium-ion battery (LIB) is an important technology for the present and future of energy storage, transport, and consumer electronics. However, many LIB types display a tendency to ignite or release gases. Although statistically rare, LIB fires pose hazards which are significantly different to other fire hazards in terms of initiation route, rate of spread, duration, toxicity, and suppression. For the first time, this paper collects and analyses the safety challenges faced by LIB industries across sectors, and compares them to the research contributions found in all the review papers in the field. The comparison identifies knowledge gaps and opportunities going forward. Industry and research efforts agree on the importance of understanding thermal runaway at the component and cell scales, and on the importance of developing prevention technologies. But much less research attention has been given to safety at the module and pack scales, or to other fire protection layers, such as compartmentation, detection or suppression. In order to close the gaps found and accelerate the arrival of new LIB safety solutions, we recommend closer collaborations between the battery and fire safety communities, which, supported by the major industries, could drive improvements, integration and harmonization of LIB safety across sectors.
3 November 2022 in ACS Applied Energy Materials
To increase the specific energy of commercial lithium-ion batteries, silicon is often blended into the graphite negative electrode. However, due to large volumetric expansion of silicon upon lithiation, these silicon-graphite (Si-Gr) composites are prone to faster rates of degradation than conventional graphite electrodes. Understanding the effect of this difference is key to controlling degradation and improving cell lifetimes. Here, the effects of state-of-charge and temperature on the aging of a commercial cylindrical cell with a Si-Gr electrode (LG M50T) are investigated. The use of degradation mode analysis enables quantification of separate rates of degradation for silicon and graphite and requires only simple in situ electrochemical data, removing the need for destructive cell teardown analyses. Loss of active silicon is shown to be worse than graphite under all operating conditions, especially at low state-of-charge and high temperature. Cycling the cell over 0-30% state-of-charge at 40 °C resulted in an 80% loss in silicon capacity after 4 kA h of charge throughput (∼400 equiv full cycles) compared to just a 10% loss in graphite capacity. The results indicate that the additional capacity conferred by silicon comes at the expense of reduced lifetime. Conversely, reducing the utilization of silicon by limiting the depth-of-discharge of cells containing Si-Gr will extend their lifetime. The degradation mode analysis methods described here provide valuable insight into the causes of cell aging by separately quantifying capacity loss for the two active materials in the composite electrode. These methods provide a suitable framework for any experimental investigations involving composite electrodes.
1 April 2021 in Journal of Power Sources
1 February 2020 in eTransportation