Ruhul Amin

Ruhul Amin

Auto-generated profile, based on publicly available information

Ruhul Amin

Electrification and Energy Infrastructures Division, Oak Ridge National Laboratory, Hardin Valley Campus, Knoxville, TN, 37830, USA

Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 April 2013 in Advanced Energy Materials
Verified
Journal Article
Open access
PDF file
DYDavid Young
David Young
ARAlan Ransil
Alan Ransil
RARuhul Amin
Ruhul Amin
ZLZheng Li
Zheng Li
YCYet‐Ming Chiang
Yet‐Ming Chiang
The electronic conductivity of lithium titanate spinel (Li4/3Ti5/3O4) is measured as a function of lithiation and temperature. The electronic conductivity of fully lithiated spinel (Li7/3Ti5/3O4) is 2.46 S cm−1 at 300 K and is weakly thermally activated. High electronic conductivity is observed over a wide lithiation range down to x~0.04 and suggests that lithium chemical diffusion is ionically limited over most of the state of charge regime.

12 February 2024 in ACS Energy Letters
Verified
Journal Article
Open access
MDMarm Dixit
Marm Dixit
ABAnuj Bisht
Anuj Bisht
RERachid Essehli
Rachid Essehli
RARuhul Amin
Ruhul Amin
CKChol-Bum M. Kweon
Chol-Bum M. Kweon
IBIlias Belharouak
Ilias Belharouak
High power is a critical requirement of lithium-ion batteries designed to satisfy the load profiles of advanced air mobility. Here, we simulate the initial takeoff step of electric vertical takeoff and landing (eVTOL) vehicles powered by a lithium-ion battery that is subjected to an intense 15C discharge pulse at the beginning of the discharge cycle followed by a subsequent low-rate discharge. We conducted extensive electrochemical testing to assess the long-term stability of a lithium-ion battery under these high-strain conditions. The main finding is that despite the performance recovery observed at low rates, the reapplication of high rates leads to drastic cell failure. While the results highlight the eVTOL battery longevity challenge, the findings also emphasize the need for tailored battery chemistry designs for eVTOL applications to address both anode plating and cathode instability. In addition, innovative second-use strategies would be paramount upon completion of the eVTOL services.

31 August 2025 in Electrochemical Energy Reviews
Verified
Journal Article
Closed access
PDF file
MRMuhammad Mominur Rahman
Muhammad Mominur Rahman
UNUmair Nisar
Umair Nisar
AAAli Abouimrane
Ali Abouimrane
IBIlias Belharouak
Ilias Belharouak
RARuhul Amin
Ruhul Amin

1 August 2018 in Journal of Power Sources
Verified
Journal Article
Closed access
UNUmair Nisar
Umair Nisar
RARuhul Amin
Ruhul Amin
RERachid Essehli
Rachid Essehli
R.  A. ShakoorR. A. Shakoor
R. A. Shakoor
RKRamazan Kahraman
Ramazan Kahraman
IBIlias Belharouak
Ilias Belharouak

23 September 2021 in ACS Energy Letters
Verified
Journal Article
Open access
APAnand Parejiya
Anand Parejiya
RARuhul Amin
Ruhul Amin
MDMarm B. Dixit
Marm B. Dixit
RERachid Essehli
Rachid Essehli
CJCharl Jeremy Jafta
Charl Jeremy Jafta
IBIlias Belharouak
Ilias Belharouak
Stabilizing interfaces in solid-state batteries (SSBs) is crucial for development of high energy density batteries. In this work, we report a facile electrochemical protocol to improve the interfacial impedance and contact at the interface of Li | Li6.25Al0.25La3Zr2O12 (LALZO). Application of short duration, high-voltage pulses to poorly formed interfaces leads to lower contact impedance. It is found that the local high current density that results from these pulses at the vicinity of the interfacial pores can lead to a better contact between Li and LALZO because of local Joule heating, as supported by theoretical simulations. The pulse technique, which has also been applied to a Li | Li6.4La3Zr1.4Ta0.6O12 (LLZTO) | LiNi0.6Mn0.2Co0.2O2 (NMC622) cell, results in remarkable reduction of the charge-transfer resistance. Ex situ characterizations, which include X-ray photoelectron spectroscopy and scanning electron microscopy techniques, reveal that there is no detrimental effects of the pulse on cathode and solid electrolyte bulks and interfaces. This electrochemical pulse technique sheds light on a facile, nondestructive method that has the potential to significantly improve the interfacial contacts in a solid-state battery configuration.

20 September 2019 in ACS Applied Energy Materials
Verified
Journal Article
Closed access
UNUmair Nisar
Umair Nisar
SASara Ahmad J. A. Al-Hail
Sara Ahmad J. A. Al-Hail
RPRamesh Kumar Petla
Ramesh Kumar Petla
R.  A. ShakoorR. A. Shakoor
R. A. Shakoor
RERachid Essehli
Rachid Essehli
RARuhul Amin
Ruhul Amin