28 December 2021 in Archives of Metallurgy and Materials
Deposition defects like porosity, crack and lack of fusion in additive manufacturing process is a major obstacle to commercialization of the process. Thus, metallurgical microscopy analysis has been mainly conducted to optimize process conditions by detecting and investigating the defects. However, these defect detection methods indicate a deviation from the operator’s experience. In this study, artificial intelligence based YOLOv3 of object detection algorithm was applied to avoid the human dependency. The algorithm aims to automatically find and label the defects. To enable the aim, 80 training images and 20 verification images were prepared, and they were amplified into 640 training images and 160 verification images using augmentation algorithm of rotation, movement and scale down, randomly. To evaluate the performance of the algorithm, total loss was derived as the sum of localization loss, confidence loss, and classification loss. In the training process, the total loss was 8.672 for the initial 100 sample images. However, the total loss was reduced to 5.841 after training with additional 800 images. For the verification of the proposed method, new defect images were input and then the mean Average Precision (mAP) in terms of precision and recall was 0.3795. Therefore, the detection performance with high accuracy can be applied to industry for avoiding human errors.
1 October 2021 in Review of Scientific Instruments
This paper presents a novel dual-mode motion mechanism capable of achieving nanopositioning on a monolithic linear motion platform. Unlike conventional dual-mode stages that use piezoelectric (PZT)- and electromagnetic-combined or similar actuation mechanisms comprising two separate motion axes, the dual-mode actuation was developed by combining a PZT for a coarse motion and a fluidic pressure-fed mechanism (FPFM) for a fine motion and was implemented in a monolithic flexure stage fabricated by metal additive manufacturing. The FPFM actuates the flexure stage by pressuring the media in the fluidic channels created inside the flexure spring structures. Experimental tests were performed to investigate the performance of the dual-mode linear motion platform. The stiffness, damping, and frequency response functions of the dual-mode stage were experimentally characterized. The proportional–integral–differential control combined with dual-mode control was employed to control the position of the flexure stage while bidirectionally controlling the flow of compressed air for a fine motion. The FPFM motion showed a good response to 1 nm stepwise input (every 10 psi), and it was implemented to provide up to ∼10 nm fine motion along with the PZT coarse motion (1 µm). The hysteresis characteristics of the FPFM were also characterized and compensated to track the positioning error.
1 March 2023 in Review of Scientific Instruments
This paper presents novel surface profilometry for both geometric part error and metallurgical material property distribution measurements of the additively manufactured and post-processed rods. The measurement system, the so-called fiber optic-eddy current sensor, consists of a fiber optic displacement sensor and an eddy current sensor. The electromagnetic coil was wrapped around the probe of the fiber optic displacement sensor. The fiber optic displacement sensor was used to measure the surface profile, and the eddy current sensor was used to measure the change in permeability of the rod under varying electromagnetic excitation conditions. The permeability of the material changes upon exposure to mechanical forces, such as compression or extension and high temperatures. The geometric part error and material property profiles of the rods were successfully extracted by using a reversal method that is conventionally used for spindle error separation. The fiber optic displacement sensor and the eddy current sensor developed in this study have a resolution of 0.286 µm and 0.00359 μr, respectively. The proposed method was applied not only to characterize the rods but also to characterize composite rods.