Stone columns with granular material are often used to support embankments over soft soil. In extremely soft soils, encasing the granular column with geosynthetic material improves their stiffness and strength. Based on the soil and column properties, settlements and stresses can be determined by means of analytical solutions or numerical analyses, and this paper compares the results of these two procedures by means of parametric analyses. Two-dimensional finite-element analysis (FEA) was used to simulate the behavior of a geosynthetic-encased stone column in soft clay loaded by an embankment. Parametric studies are then carried out by varying the thickness of the soft soil layer and the tensile stiffness of the geosynthetic encasement for a given set of soft clay and column parameters. The results of FEA have shown that the influence of the geosynthetic encasement on settlement improvement increases in shallow soft soil layers. It was also observed that the dependence of stress concentration on the thickness of the soft soil increases with geosynthetic stiffness. The critical embankment height where ground settlement is negligible was also investigated.
A full-scale test embankment was constructed on a soft deposit (Su < 20 kPa) improved by geotextile-encased granular columns to assess its serviceability performance for a nearby stockyard foundation. The behaviour of the improved foundation was monitored by means of instrumentation with respect to surface settlements, excess pore pressures, total vertical stresses acting on the top of the encased column and surrounding soft soil as well as geotextile radial deformation. Two-dimensional finite-element analysis was performed using an axi-symmetric unit cell, and then the results were compared with field measurements. It was observed that the soil arching progressed during post-construction due to a decrease in apparent stiffness of soft clay from quasi undrained to drained stiffness. Furthermore, there was a difference in settlement between the top of the encased column and the surrounding soft soil, midpoint between the columns, which increased during both construction and consolidation stages. A measured relation was also found to correlate the geotextile expansion with the maximum settlement occurring below the embankment.
1 April 2019 in Journal of Rock Mechanics and Geotechnical Engineering
The soil reinforcement method, which consists of placing a granular mattress above a set of rigid inclusions, is used to transfer part of the surface load to the piles through arching. The addition of an extensible geosynthetic layer at the base of the mattress increases load transfer. A small-scale centrifuge model, the mobile tray device, is used to simulate the foundation behaviour by modelling soft soil settlement between the inclusions. A parametric study was conducted to examine the influence of the mattress thickness and of the pile spacing. The different test configurations are compared with regard to the stress transmitted to soft soil, to differential settlement and to the efficiency of load transfer. With thicker mattresses and/or closer pile meshing, load transfer increases and surface settlements are reduced. Geosynthetic maximum experimental and analytical deflections are also examined. For the analytical study, conducted using the EBGEO German standard, three different distributions of the vertical stress applied to the geosynthetic layer are compared: uniform, triangular and inverse triangular. All three scenario results fall within the range of the experimental results. The inverse triangular distribution reveals some deflection values that were lower than the uniform one. The triangular distribution gives the highest deflection values.
17 January 2017 in Geotechnical and Geological Engineering
Soft ground improvement techniques have evolved substantially in Brazil in recent years. However, their application in soft and very soft clays requires a good understanding of the fundamentals of ground improvement techniques suited to the problem as well as the actual field behavior when implemented on a real scale. This paper describes some of the most widely used ground improvement techniques in the context of very soft clays in Brazil. The techniques described in the paper use prefabricated vertical drains (PVD) such as vacuum preloading; or combine PVD and rigid inclusion, such as CPR grouting; or are purely column-like elements such as piled embankments (including those executed with the deep mixing technique, DSM); or combine column-like elements with the drainage function, such as stone columns and geosynthetic encased columns; or use cementitious binders such as shallow soil mixing. The paper reference condition is a soft clay foundation in which no strengthening is implemented, such as, an embankment with basal reinforcement or soft clay with vertical prefabricated drains, or the use of vacuum preloading to speed up the consolidation rate. The applications of the ground improvement techniques are illustrated by case histories, numerical analyses, or physical models. Different types of measurements are used to evaluate the performance of each technique, including settlements, horizontal displacements, excess pore pressures, embankment applied stresses, stress concentration factors, and clay strength following the ground treatment. The settlement improvement factor β, the ratio between the settlements for untreated and treated conditions, is shown to be a suitable parameter to assess the degree of improvement imposed in the soft foundation by ranking the various methods in increased order of strengthening effect.