20 June 2017 in Rapid Prototyping Journal
Purpose: This paper aims to present the methodology and results of the experimental characterization of three-dimensional (3D) printed acrylonitrile butadiene styrene (ABS) and polycarbonate (PC) parts utilizing digital image correlation (DIC). Design/methodology/approach: Tensile and shear characterizations of ABS and PC 3D-printed parts were performed to determine the extent of anisotropy present in 3D-printed materials. Specimens were printed with varying raster ([+45/−45], [+30/−60], [+15/−75] and [0/90]) and build orientations (flat, on-edge and up-right) to determine the directional properties of the materials. Tensile and Iosipescu shear specimens were printed and loaded in a universal testing machine utilizing two-dimensional (2D) DIC to measure strain. The Poisson’s ratio, Young’s modulus, offset yield strength, tensile strength at yield, elongation at break, tensile stress at break and strain energy density were gathered for each tensile orientation combination. Shear modulus, offset yield strength and shear strength at yield values were collected for each shear combination. Findings: Results indicated that raster and build orientations had negligible effects on the Young’s modulus or Poisson’s ratio in ABS tensile specimens. Shear modulus and shear offset yield strength varied by up to 33 per cent in ABS specimens, signifying that tensile properties are not indicative of shear properties. Raster orientation in the flat build samples reveals anisotropic behavior in PC specimens as the moduli and strengths varied by up to 20 per cent. Similar variations were observed in shear for PC. Changing the build orientation of PC specimens appeared to reveal a similar magnitude of variation in material properties. Originality/value: This article tests tensile and shear specimens utilizing DIC, which has not been employed previously with 3D-printed specimens. The extensive shear testing conducted in this paper has not been previously attempted, and the results indicate the need for shear testing to understand the 3D-printed material behavior fully.
28 September 2010 in Experimental Mechanics
20 November 2014 in Structural and Multidisciplinary Optimization
6 March 2018 in Journal of Manufacturing Science and Engineering
Machining is among the most versatile material removal processes in the manufacturing industry. To better optimize the machining process, the knowledge of shear strains and shear strain rates within the primary shear zone (PSZ) during chip formation has been of great interest. The objective of this study is to study the strain and strain rate progression within the PSZ both in the chip flow direction and along the thickness direction during machining equal channel angular extrusion (ECAE) processed titanium (Ti). ECAE-processed ultrafine-grained Ti has been machined at cutting speeds of 0.1 and 0.5 m/s, and the shear strain and the shear strain rate have been determined using high speed imaging and digital image correlation (DIC). It is found that the chip morphology is saw-tooth at 0.1 m/s while continuous at 0.5 m/s. The cumulative shear strain and the incremental shear strain rate of the saw-tooth chip morphology can reach approximately 3.9 and 2.4 × 103 s−1, respectively, and those of the continuous chip morphology may be approximately 1.3 and 5.0 × 103 s−1, respectively. There is a distinct peak shift in the shear strain rate distribution during saw-tooth chip formation while there is a stable peak position of the strain rate distribution during continuous chip formation. The PSZ thickness during saw-tooth chip formation is more localized and smaller than that during continuous chip formation (28 versus 35 μm).