This article presents an enhanced-frequency-splitting-based wireless power and data transfer (EFS-WPDT) system that simultaneously delivers power and forward data over a compact inductive link. For data transmission, the proposed system employs frequency-shift keying (FSK) based on frequency-splitting enhancement (FSE), which is enabled by dynamic link-load isolation (LLI) and time-interleaved $LC$ resonance. This approach effectively addresses the conventional tradeoffs among power delivered to the load (PDL), data rate (DR), and power transfer efficiency (PTE). The dynamic LLI decouples the load during each resonance phase, which is critical for enabling FSE, and is implemented using a quasi-resonant boost converter (QRBC) that provides a boosted and regulated output voltage. For time-interleaved operation, reliable peak detection is achieved by a body-tuned peak detector (BTPD), which maintains accurate timing across varying link conditions. A frequency-to-amplitude converter enhances sensitivity by amplifying envelope differences, enabling robust data demodulation even in the miniaturized link. The presented ICs, fabricated in a 180-nm bipolar-CMOS-DMOS (BCD) process, simultaneously achieve 60.2% overall PTE, 43.4-mW PDL, and 1-Mb/s DR with a sub-centimeter receiver (RX) coil. As a result, the figure of merit (FoM) for data transmission is improved to a level comparable to previous works using centimeter-scale links, while the FoM for power delivery is improved by $2.5\times $ compared to prior state-of-the-art systems, employing a single inductive link.
15 December 2025 in IEEE Open Journal of the Solid-State Circuits Society
Wireless capsule endoscopy requires simultaneous support of ultra-low-power operation and high data rate to enable long diagnostic time and reliable image transmission. To support both design requirements, this work presents a 75-pJ/bit 435-MHz modulator for 16 quadrature amplitude modulation (16-QAM) with aggressive symbol-level duty cycling (SLDC). SLDC is supported by a fast startup technique, which enhances duty cycling efficiency. During startup, the proposed technique minimizes transient DC error components at the modulator input, which results in fast settling of the output envelope. A fully on-chip auto calibration detects and corrects this error without impacting modulator performance. The calibration is fully digital, scalable, and robust against process, voltage, and temperature variations. After the calibration process, the modulator exhibits a 20-ns startup time. Even with 50% symbol-level duty cycling, a data rate of 20 Mbps is achieved with -8-dBm average output power and 1.6-mW power consumption. Combining spectrum-efficient QAM and SLDC, this work satisfies both low-power and high-data-rate requirements for wireless medical capsule endoscopy (WMCE).