Feridoon Jalili

Feridoon Jalili

Auto-generated profile, based on publicly available information

Feridoon Jalili

Department of Electronic Systems, Aalborg University, Aalborg, Denmark

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 June 2020 in IEEE Access
Verified
Journal Article
Open access
FJFeridoon Jalili
Feridoon Jalili
FTFelice Francesco Tafuri
Felice Francesco Tafuri
OJOle Kiel Jensen
Ole Kiel Jensen
YLYunfeng Li
Yunfeng Li
Ming ShenMing Shen
Ming Shen
GPGert F. Pedersen
Gert F. Pedersen
The new generation of 5G mobile communication systems is using millimeter wave (mmWave) active phased arrays (APA) which have up to hundreds of individual analog transmitter and receiver chains and antennas. For these highly integrated systems linearization of each analog path is very challenging. Therefore a single input single output (SISO) system in combination with over the air (OTA) measurement is considered as an efficient approach for linearization. However, the knowledge about the dependency of the total SISO nonlinearity on the contributions from different blocks in the antenna array, as well as the linearization trade-offs is still missing. In this paper, an overview of the possible linearization trade-offs in an OTA setup with a mmWave APA is provided. The linearization technique is applied to a 4x4 active phased array containing up-conversion of a sub 6 GHz LTE10 signal to an RF frequency of 28 GHz. Through measurements, the effects on adjacent channel power ratio (ACPR) and error vector magnitude (EVM) have been investigated for the following scenarios: i. impact from the up-converter, ii. impact of the steering angle due to antenna crosstalk and iii. a linearity comparison between a linearized and a backed-off system.

6 February 2023 in IEEE Access
Verified
Journal Article
Open access
FJFeridoon Jalili
Feridoon Jalili
FTFelice Francesco Tafuri
Felice Francesco Tafuri
OJOle Kiel Jensen
Ole Kiel Jensen
QCQingyue Chen
Qingyue Chen
Ming ShenMing Shen
Ming Shen
YLYunfeng Li
Yunfeng Li
This paper proposes a transfer learning neural network (TLNN) approach for digital predistortion (DPD) of mm-Wave active phased arrays (APA) operated under variable signal bandwidth regimes. Compared with the conventional artificial neural network (ANN) method, the proposed approach can achieve similar linearization performance with much lower computational complexity by transferring part of a trained model from one bandwidth to another bandwidth. In the recently introduced 5G, the increased signal bandwidth triggers considerable memory effects in the APA. Moreover, dealing with different signal bandwidths typically requires a time-consuming recalculation of the predistorter parameters. In this paper, the authors propose to have those challenges solved by using a DPD model based on the transfer learning method. The proposed approach was validated with over-the-air (OTA) measurements on an APA excited with signals of varying bandwidth, namely from 20 MHz to 100 MHz. Experimental results show a significant reduction in the training time while ensuring good linearization performance. With the applied TLNN DPD, an 8.5 dB improvement of adjacent channel leakage ratio (ACLR) and 8.6 % points improvement of error vector magnitude (EVM) is achieved. Under the variable bandwidth regime, the complexity of the DPD model in terms of the number of multiplications is reduced from 199168 to 160. The proposed TLNN DPD proved to be robust concerning variation in the bandwidth of the APA excitation signal.

5 October 2021 in IEEE Access
Verified
Journal Article
Open access
QCQingyue Chen
Qingyue Chen
YZYufeng Zhang
Yufeng Zhang
FJFeridoon Jalili
Feridoon Jalili
ZWZhugang Wang
Zhugang Wang
YHYonghui Huang
Yonghui Huang
Ming ShenMing Shen
Ming Shen
This paper proposes a robust digital signal recovery (DSR) technique to tackle the high signal-to-noise ratio (SNR) variation and transmitter memory effects for broadband power efficient down-link in next-generation low Earth orbit (LEO) satellite constellations. The robustness against low SNR is achieved by concurrently integrating magnitude normalization and noise feature filtering using a filtering block built with one batch normalization (BN) layer and two bidirectional long short-term memory (BiLSTM) layers. Moreover, unlike existing deep neural network-based DSR techniques (DNN-DSR), which failed to effectively take into account the memory effects of radio-frequency power amplifiers (RF-PAs) in the model design, the proposed BiLSTM-DSR technique can extracts the sequential characteristics of the adjacent in-phase (I) and quadrature (Q) samples, and hence can obtain superior memory effects compensation compared with the DNN-DSR technique. Experimental validation results of the proposed BiLSTM-DSR with a 100 MHz bandwidth OFDM signal demonstrate an excellent performance of 11.83 dB and 9.4% improvement for adjacent channel power ratio (ACPR) and error vector magnitude (EVM), respectively. BiLSTM-DSR also outperforms the existing DNN-DSR technique in terms of the ACPR and EVM by 2.4 dB and 0.9%, which provides a promising solution for developing deep learning-assisted receivers for high-throughput LEO satellite networks.

1 October 2019
Verified
Conference Paper
Closed access
FJFeridoon Jalili
Feridoon Jalili
MNMartin H. Nielsen
Martin H. Nielsen
Ming ShenMing Shen
Ming Shen
OJOle K. Jensen
Ole K. Jensen
JMJan Hvolgaard Mikkelsen
Jan Hvolgaard Mikkelsen
GPGert F. Pedersen
Gert F. Pedersen
By increasing the number of antennas and power amplifiers connected to each in 5G system, the linearization methods like digital pre-distortion (DPD) of each power amplifier is inefficient due to antenna imperfections such as crosstalk. As a result of limited area the distance between antennas in array can vary which leads to unwanted coupling between antennas. A solution to this problem could be treating the amplifiers and antennas as one system and linearizing the main beam signal at the receiver rather than on each single power amplifier. In the work described in this paper, the whole system including amplifiers, antennas and the receiver is treated as a 2-ports system and the impacts of the above mentioned constraints are investigated.

22 August 2021 in Electronics
Verified
Journal Article
Open access
PDF file
YLYunfeng Li
Yunfeng Li
YHYonghui Huang
Yonghui Huang
MNMartin Hedegaard Nielsen
Martin Hedegaard Nielsen
FJFeridoon Jalili
Feridoon Jalili
WWWei Wei
Wei Wei
GPGert F. Pedersen
Gert F. Pedersen
A cross-mode universal digital pre-distortion (CMUDPD) technology is proposed here to linearize low-sidelobe active antenna arrays with non-uniform fixed power levels for each branch, which are desired in satellite communications with stringent requirements to minimize interference. In low-sidelobe arrays formed by nonuniform amplitude excitation, conventional digital pre-distortion (DPD) techniques require multiple feedback paths for either one-to-one or average linearization of the PAs, which increases system complexity and is infeasible for large-scale arrays. This is because the power amplifiers (PAs) usually operate in different modes where the supply voltages, bias voltages, and input power levels are different. The proposed CMUDPD method aims at solving this issue by intentionally arranging the PAs to work in different modes but with shared nonlinear characteristics. Based on the nonlinear correlation established among the PAs’ different operating modes, a single feedback path is sufficient to capture the common nonlinearity of all the PAs and determine the parameters of the CMUDPD module. The concept is explained in theory and validated by simulations and experiments using GaN PAs operating with three significantly different output power levels and two orthogonal frequency division multiplexing (OFDM) signal bandwidths.

9 June 2022 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
QCQingyue Chen
Qingyue Chen
YLYunfeng Li
Yunfeng Li
FJFeridoon Jalili
Feridoon Jalili
ZWZhugang WANG
Zhugang WANG
OJOle Kiel Jensen
Ole Kiel Jensen
Ming ShenMing Shen
Ming Shen
This brief proposes a digital signal recovery (DSR) method to compensate the nonlinear distortion introduced by power amplifiers (PAs) under dynamic nonlinear operating states. Unlike conventional PA linearization methods that extract the nonlinearity based on the baseband I/Q PA input and output signal samples, the proposed method attempts to derive the memory polynomial (MP) model parameters based on PA operating states using a deep neural network (DNN). This method allows the receiver to achieve DSR by tracking the operating states of the PA effectively with a few telemetry data. Validation results from simulations and experiments based on a GaN PA operating at 3.5 GHz reveal that the proposed method can maintain satisfactory DSR performance in terms of adjacent channel power ratio (ACPR) and error vector magnitude (EVM) while the transmitter PA is operating with fluctuating average input/output power, supply voltage, and bias voltage. The training data size and time are further reduced by using a transfer learning (TL) approach.