The Dzyaloshinskii-Moriya interaction (DMI) at the heavy metal (HM) and ferromagnetic metal (FM) interface has been recognized as a key ingredient in spintronic applications. Here we investigate the chemical trend of DMI on the band filling () of the HM element in HM/FM multilayer thin films. DMI is quantitatively evaluated by measuring asymmetric spin wave dispersion using Brillouin light scattering. Sign reversal and 20 times modification of the DMI coefficient have been measured as the HM element is varied. The chemical trend can be qualitatively understood by considering the and bands alignment at the HM/FM interface and the subsequent orbital hybridization around the Fermi level. Furthermore, a correlation is observed between DMI and effective spin mixing conductance at the HM/FM interfaces. Our results provide new insights into the interfacial DMI for designing future spintronic devices.
We review the recent progress in the development of magnetoelectric RAM (MeRAM) based on electric-field-controlled writing in magnetic tunnel junctions (MTJs). MeRAM uses the tunneling magnetoresistance effect for readout in a two-terminal memory element, similar to other types of magnetic RAM. However, the writing of information is performed by voltage control of magnetic anisotropy (VCMA) at the interface of an MgO tunnel barrier and the CoFeB-based free layer, as opposed to current-controlled (e.g., spin-transfer torque or spin-orbit torque) mechanisms. We present results on voltage-induced switching of MTJs in both resonant (precessional) and thermally activated regimes, which demonstrate fast (<;1 ns) and ultralow-power (<;40 fJ/bit) write operations at voltages ~1.5-2 V. We also discuss the implications of the VCMA-based write mechanism on memory array design, highlighting the possibility of crossbar implementation for high bit density. Results are presented from a 1 kbit MeRAM test array. Endurance and voltage scaling data are presented. The scaling behavior is analyzed, and material-level requirements are discussed for the translation of MeRAM into mainstream memory applications.
We studied the impact of different insertion layers (Ta, Pt, and Mg) at the CoFeB|MgO interface on voltage-controlled magnetic anisotropy (VCMA) effect and other magnetic properties. Inserting a very thin Mg layer of 0.1–0.3 nm yielded a VCMA coefficient of 100 fJ/V-m, more than 3 times higher than the average values of around 30 fJ/V-m reported in Ta|CoFeB|MgO-based structures. Ta and Pt insertion layers also showed a small improvement, yielding VCMA coefficients around 40 fJ/V-m. Electrical, magnetic, and X-ray diffraction results reveal that a Mg insertion layer of around 1.2 nm gives rise to the highest perpendicular magnetic anisotropy, saturation magnetization, as well as the best CoFe and MgO crystallinity. Other Mg insertion thicknesses give rise to either under- or over-oxidation of the CoFe|MgO interface; a strong over-oxidation of the CoFe layer leads to the maximum VCMA effect. These results show that precise control over the Mg insertion thickness and CoFe oxidation level at the CoFeB|MgO interface is crucial for the development of electric-field-controlled perpendicular magnetic tunnel junctions with low write voltage.
Manipulating magnetism by electric current is of great interest for both fundamental and technological reasons. Much effort has been dedicated to spin–orbit torques (SOTs) in metallic structures, while quantitative investigation of analogous phenomena in magnetic insulators remains challenging due to their low electrical conductivity. Here we address this challenge by exploiting the interaction of light with magnetic order, to directly measure SOTs in both metallic and insulating structures. The equivalency of optical and transport measurements is established by investigating a heavy-metal/ferromagnetic-metal device (Ta/CoFeB/MgO). Subsequently, SOTs are measured optically in the contrasting case of a magnetic-insulator/heavy-metal (YIG/Pt) heterostructure, where analogous transport measurements are not viable. We observe a large anti-damping torque in the YIG/Pt system, revealing its promise for spintronic device applications. Moreover, our results demonstrate that SOT physics is directly accessible by optical means in a range of materials, where transport measurements may not be possible.