1 July 2017 in Powder Metallurgy
The new HIP cooling systems enable very fast cooling rates under isostatic pressure. This does not only enable shorter HIP cycles but also allows complete heat treatment cycles to be performed in one HIP cycle. It has been shown in previous studies that extreme pressures of several thousand bar can push phase transformation towards longer times. The new URQ HIP cooling systems give the opportunity to investigate the impact of pressures up to 2000 bar on phase transformation time dependency. For each of the two materials in this study, a comparison of austenite phase transformation time at 100 and 1700 bar was performed. The study was performed by isothermal heat treatment of specimens for a specific time followed by quenching. To evaluate the influence of pressure on hardenability, the phase fractions were evaluated using grid method on SEM images. The study found significant influence of HIP pressure on hardenability.
20 September 2016 in Materials Science and Technology
Ultra-high strength steel sheets have been subjected to heat treatments that simulate the thermal cycles in hot-dip galvanising and galvannealing processes and evaluated with respect to their resulting mechanical properties and microstructures. The steels contained suitable contents of carbon (∼0.2%), manganese (1.2%) and chromium (0.4%) to ensure that they could be fully transformed to martensite after austenitisation followed by rapid cooling in a continuous annealing line, prior to galvanising. Different contents of vanadium (0–0.1%) and nitrogen (0.002–0.012%) were used to investigate the possible role of these microalloying elements on the strength of the tempered martensite. Vanadium, especially when in combination with a raised nitrogen content, helps to resist the effect of tempering so that a larger proportion of the initial strengthening is preserved after the galvanising cycle, giving tensile strength levels exceeding 1000 MPa. Different deoxidation practices using aluminium or silicon have also been included. These showed similar strength levels at corresponding carbon contents but the bendability of the Si-killed steel sheet was considerably superior. Microstructural examinations have been made on the annealed steels but the reason for the beneficial effect of vanadium is still not fully explained. It is concluded that microalloying with vanadium is a very promising approach in the development of corrosion-resistant ultra-high strength steel sheet products.