Strain field evolution on the surface of aluminum sheet D16 and 2024-T3 alloys has been analyzed during static deformation and during specific high-speed impact and oscillation loading—dynamical non-equilibrium process. Experiments have been conducted using an original mechanical testing technique and a specially developed software solution for non-contact study of strain field using digital image correlation fitted with a high-speed camera. It has been established that deformation process kinetics for tested aluminum alloys after a dynamical non-equilibrium process during further static deformation changes as compared with a process of static deformation mainly manifests itself in the increase in general alloy ductility and delay in “neck formation.” It has been shown that strain field is an important indicator for deformation band structure formation in the tested materials.
20 December 2014 in JOURNAL OF CIVIL ENGINEERING AND MANAGEMENT
The effect of the in-service scattered damage in the pipe wall metal is evaluated, and the effect of hydrogen absorbed by metal on the variation of the structure and mechanical properties of the main gas pipeline after a long-term operation is found. The main regularities in the graded nature of the static deformation process and the effect of hydrogenation on the scattered damage and fracture accumulation are found.
The purpose of this paper is to provide new experimental data for high-strength VT 22 titanium α + β-type alloy under impact-oscillatory loading and dynamic non-equilibrium process. Based on the performed experimental studies, it was found that overall plastic deformation of this alloy can be increased by a factor 2.75 compared with its initial state without significant loss of strength. To achieve this goal, a new methodology to study the impact behaviour of materials under non-equilibrium process has been used. Physical research revealed that significant microstructural refinement of the alloy is observed after such type of loading, as the result of which the fine grains are formed with subgrain refinement which takes place within the basis of alloy.
New experimental results on the effect of additional force impulse loading on the variation of the initial structure of the aircraft material (alloys D16, 2024-T3, VT22) at various stages of deformation are presented and a significant enhancement of its initial plasticity is achieved. Complex investigations into the material properties after a dynamic non-equilibrium process made it possible to describe the main regularities in the nature of deformation and fracture of materials, which allowed proposing general recommendations on using the revealed physical and mechanical regularities in the evaluation of strength of aircraft structures.
A simple technological method is proposed and tested experimentally, which allows for the improvement of mechanical properties in sheet two-phase high-strength titanium alloys VT23 and VT23M on the finished product (rolled metal), due to impact-oscillatory loading. Under impact-oscillatory loading and dynamic non-equilibrium processes (DNP) are realized in titanium alloys, leading to the self-organization of the structure. As a result, the mechanical properties of titanium alloys vary significantly with subsequent loading after the realization of DNP. In this study, the test modes are found, which can be used in the production conditions.
1 August 2009 in Theoretical and Applied Fracture Mechanics