Delineating Deep Faults: Most large, damaging earthquakes initiate in Earth's crust where friction and brittle fracture control the release of energy. Strong earthquakes can occur in the mantle too, but their rupture dynamics are difficult to determine because higher temperatures and pressures play a more important role.
Ye
et al. (p. 1380 ) analyzed seismic P waves generated by the 2013 Mw 8.3 Sea of Okhotsk earthquake—the largest deep earthquake recorded to date—and its associated aftershocks. The earthquake ruptured along a fault over 180-kilometer-long and structural heterogeneity resulted in a massive release of stress from the subducting slab. In a set of complementary laboratory deformation experiments,
Schubnel
et al. (p. 1377 ) simulated the nucleation of acoustic emission events that resemble deep earthquakes. These events are caused by an instantaneous phase transition from olivine to spinel, which would occur at the same depth and result in large stress releases observed for other deep earthquakes.
Fluid‐induced stress perturbations in the crust at seismogenic depths caused by sources such as tidal or seasonal loading may trigger earthquakes. We investigate the role of small periodic pore pressure (Pp) perturbation in rupture nucleation by performing laboratory triaxial creep experiments on Fontainebleau sandstone, saturated in water, under sinusoidal Pp variations. Results show that recorded acoustic emissions (AEs) correlate with Pp as the rock approaches failure. More interestingly, AEs occur significantly more when Pp is decreasing, that is, when strain rate is maximum with a progressive increase of Pp‐AEs correlation in time as the rock approaches failure. This suggests that the correlation of small stress perturbations and AEs not only depends on Pp amplitude but also on the criticality of the rock. Observations at the laboratory scale support field observations where tidal loading may have modulated seismic rates during the nucleation phase of the 2004 Sumatra‐Andaman and 2011 Tohoku‐Oki earthquakes.
12 May 2018 in Journal of Geophysical Research: Solid Earth
In the Balmuccia massif (NW Italy), a pseudotachylyte vein network (N068 trending) in a spinel lherzolite is interpreted as the product of frictional melting during a single Mw > 6 earthquake. The subvertical fault underwent a metric dextral coseismic displacement, raking 60°SW. The average width of the main slip surface is ~ 5 mm. A dense network of thin (20–200 μm) injection and ultramylonite‐like veins decorates the fault walls. In the injection veins, Raman microspectrometry mapping reveals pockets of still preserved amorphous silicate, containing ≈ 1% of structurally bound H2O. In the ultramylonite‐like veins, electron backscattered diffraction mapping reveals that ultrafine (0.2–2 μm) olivine grains exhibit a strong fabric with (010) planes parallel to shearing, consistent with temperatures above 1250°C during deformation and suggesting fast recrystallization from the frictional melt. The veins also exhibit pyroxene and recrystallized spinel, which proves that the earthquake occurred at a minimum depth of 40 km. The energy balance demonstrates that complete fault lubrication must have occurred during coseismic sliding (i.e., dynamic friction coefficient ≪ 0.1). Because of the low viscosity of slightly hydrated ultramafic liquids (≈ 1 Pa·s), we argue that lubrication was only transient, as the melt could rapidly flow into tensile fractures, which led to rapid cooling and promoted strength recovery and sliding arrest. Combined together, our observations suggest that this pseudotachylyte is the frozen record of a deep (>40 km) earthquake of 6 < Mw < 7. Its focal mechanism is deduced from the crystal preferred orientation due to late coseismic creep in ultramylonite‐like veins and deciphered by electron backscattered diffraction.