28 June 2023 in Analytica Chimica Acta
Systematic selection of mobile phase and column chemistry type can be critical for achieving optimal chromatographic separation, high sensitivity, and low detection limits in liquid chromatography electrospray high resolution mass spectrometry (LC/MS). However, the selection process is challenging for non-targeted screening where the compounds of interest are not preselected nor available for method optimization. To provide general guidance, twenty different mobile phase compositions and four columns were compared for the analysis of 78 compounds with a wide range of physicochemical properties (logP range from -1.46 to 5.48), and analyte sensitivity was compared between methods. The pH, additive type, column, and organic modifier had significant effects on the analyte response factors, and acidic mobile phases (e.g. 0.1% formic acid) yielded highest sensitivity. In some cases, the effect was attributable to the difference in organic modifier content at the time of elution, depending on the mobile phase and column chemistry. Based on these findings, 0.1% formic acid, 0.1% ammonia and 5.0 mM ammonium fluoride were further evaluated for their performance in non-targeted LC/ESI/HRMS analysis of wastewater treatment plan influent and effluent, using a data dependent MS2 acquisition and two different data processing workflows (MS-DIAL, patRoon 2.1) to compare number of detected features and sensitivity. Both data-processing workflows indicated that 0.1% formic acid yielded the highest number of features in full scan spectrum (MS1), as well as the highest number of features that triggered fragmentation spectra (MS2) when dynamic exclusion was used.
10 August 2026 in Progress in Agricultural Engineering Sciences
Lunar regolith is a potential substrate for plant cultivation in future bioregenerative life-support systems; however, its distinct physicochemical properties pose challenges for plant growth. In this study, white mustard was grown in mare (LMS) and highland-type (LHS) regolith simulants, each separated into fine and coarse particle-size fractions, with perlite as a control. Germination was successful across all treatments. Biomass production and reproductive performance were generally lower in regolith simulants compared with the control. Plants grown in LMS produced slightly lighter seeds than those grown in LHS, with statistically significant differences observed in the LMS coarse fraction. These results likely reflect differences in simulant chemistry, as LMS contains higher concentrations of Fe, Mg, and trace elements that may influence plant physiological responses. Particle-size distribution also affected substrate behavior, with fine fractions showing higher water retention and coarse fractions improving aeration but reducing moisture availability. These results clarify that both substrate chemistry and particle size critically affect plant productivity in lunar regolith-based agriculture.