Jiarui Ren

Jiarui Ren

Auto-generated profile, based on publicly available information

Jiarui Ren

College of Electronic Information and Optical Engineering, Nankai University, Tianjin, China

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 May 2025 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
JRJiarui Ren
Jiarui Ren
YGYadong Guo
Yadong Guo
YSYikai Sun
Yikai Sun
FLFeng Luo
Feng Luo
YZYue Zhao
Yue Zhao
ZXZhiming Xiao
Zhiming Xiao
This article proposes a symmetrical inductor current based spread-spectrum frequency modulation (SIC-SSFM) scheme for buck converters, aiming at optimizing both the electromagnetic interference (EMI) and the output voltage ripple. Compared with conventional frequency modulation approach, the proposed symmetrical structure helps minimize the averaged inductor current ripple and thus the output ripple. By utilizing the proposed method, the proposed buck converter eliminates the need for oscillators or any slope compensation, effectively optimizing the quiescent power consumption. The proposed converter supports input and output ranges of 5–40 V and 3.3–5 V, respectively. It is capable of delivering 2A maximum load while consumes only 8.4 μA quiescent current. The measured output ripple is 9–12.5 mV, achieving a peak efficiency of 93.36%, while the measured EMI is reduced by 18.5 dB due to the proposed SIC-SSFM. The active SIC-SSFM circuit occupies an area of 0.06 mm2, with a total buck area of 2.32 mm×1.88 mm.

7 December 2023 in Electronics Letters
Verified
Journal Article
Open access
JRJiarui Ren
Jiarui Ren
YZYue Zhao
Yue Zhao
ZXZhiming Xiao
Zhiming Xiao
High step‐down DC‐DC converters require a robust and low power pre‐regulated supply for bandgap reference. This paper proposes a structure that comprised of two current paths to achieve energy efficient pre‐regulation under high and low input voltage conditions. The design eliminated large size resistors for current limiting which is usually required for high input supplies. The presented pre‐regulator structure combined with the bandgap circuit was realized with the TSMC 180‐nm BCD process. The measured results show the proposed structure has a wide input voltage range of 3.5–45 V, a temperature coefficient of 5.63 ppm/°C and typical average current consumption of 1.1 μA.