1 September 2016 in Electrochimica Acta
The corrosion of high level nuclear waste containers under permanent disposal conditions can occur via a number of processes which change in importance as the environment within a deep geologic repository evolves from oxic to anoxic. The container design involves a copper coating on a steel vessel. The characteristics of these coatings are being assessed using standard analytical methods, including microscopy and electron backscatter diffraction. The corrosion processes on the surface of the coatings and at through-coating defects are also being investigated electrochemically. Although minor differences exist, the surface corrosion of cold sprayed and electrodeposited coatings generally exhibited similar corrosion behaviour to standard wrought copper. Corrosion at the base of a simulated through-coating defect in a cold-sprayed coating was found to proceed via galvanic coupling to oxygen reduction on the coating surface. Besides accumulating damage at the base of the defect, corrosion propagated along the copper/steel interface, most likely a consequence of the damage inflicted during the deposition process
1 August 2018 in Corrosion Science
12 July 2015 in Corrosion
The corrosion behavior of copper cold spray coatings on a carbon steel substrate was compared to that of commercially available wrought copper under the conditions anticipated in a nuclear waste repository. Corrosion potential and linear polarization resistance measurements were conducted over 90 d to 120 d in 3.0 mol/L NaCl under anoxic (1) and oxygenated-to-anoxic (2) conditions to simulate the long (1) and short (2) term redox conditions expected in a Canadian repository. Scanning electron microscopy and x-ray diffractometry were used to observe the morphology of the corroded surface and to identify the corrosion products formed. The two specimens behaved very similarly under both sets of conditions. Negligible corrosion was observed under anoxic conditions and the formation of both Cu+1 (Cu2O) and Cu+2 (Cu2(OH)3Cl) phases occurred under oxygenated conditions. No evidence was observed to suggest the particle boundaries in the cold sprayed coating were preferential corrosion sites.
19 June 2025 in Corrosion Science