5 October 2023 in Optics Letters
We demonstrate a 417 W, 175 kHz Innoslab chirped pulse amplification laser compressible to short and clean 406 fs pulse duration. A spectral bandwidth (full width at half maximum, FWHM) of ∼3 nm was maintained at full pump power, and the pulses exhibited good pulse quality in a wide tunable pulse energy range from 1.7 mJ to a maximum of 2.38 mJ. At the maximum output power, the compressed pulses were nearly pedestal free. The comprehensive effects of residual high-order dispersion from the front end, the gain shaping effects of the amplifier, and the slight mismatch of third-order dispersion (TOD) between the stretcher (CFBG) and the gating compressor, along with the small nonlinear phase shift accumulated in the amplifier, could have facilitated the high pulse quality. To the best of our knowledge, this is the shortest pulse duration from the Innoslab amplifiers at hundreds of watts average power in the millijoule energy regime.
28 November 2023 in Optics Letters
A high-power regenerative amplifier (RA) based on dual-slab Yb:KGd(WO4)2 (Yb:KGW) was demonstrated, which provided a maximum average power of 33.7 W at a repetition rate of 75–200 kHz before compression with a central wavelength of 1039 nm, corresponding to an optical-to-optical conversion efficiency of 51.4%. To the best of our knowledge, this is the highest average power from the Yb:KGW solid-state RA. The compressed pulse duration of 205 fs was realized under the maximum output power. By adjusting the gain of the crystals, respectively, the spectral shaping can be achieved. A combination spectrum with root-mean-square (RMS) bandwidth of 4.5 nm was generated with a central wavelength of 1035 nm at an output power of 20 W, the compressed pulse duration was 159 fs. Meanwhile, effective mitigation of thermal effects by dual-slab configuration guaranteed the nearly diffraction-limited beam quality: M
x
2 = 1.17 and M
y
2 = 1.20.
17 March 2025 in Optics Express
We demonstrate a high energy nonlinear pulse compression scheme based on a hybrid bulk-air multi-pass cell (MPC), achieving a high-power ultrafast source with 45 fs pulse duration, 130 W average power at 200 kHz repetition rate, and near-diffraction-limited beam quality. The impact of air nonlinearity accumulation in the MPC on beam quality is investigated to maintain good beam quality at high pulse energy, which suggests the adoption of pre-chirped and circularly-polarized pulses can effectively improve the input pulse energy and suppress the spatial quality degradation. The nonlinear mode-matching is also adopted to minimize the impact of the self-focusing effect of solid-thin-plates on q-preserving propagation. Although both solid plates and air contribute to the spectral broadening, the hybrid MPC is still an all-solid-state configuration without a pressure-controlled cell, providing a compact and economical approach for the nonlinear pulse compression at several hundred microjoules (µJ) energy levels. To the best of our knowledge, this is the highest pulse energy from the solid-state MPC configuration.
28 April 2025 in Optics Express
We demonstrated a high average power dual-crystal Yb:CALGO regenerative amplifier(RA) operated in TEM00 mode. The dual-crystal configuration effectively mitigated thermal effects and enabled a continuous output power of 42.5 W at a pump power of 160 W with the central wavelength of 1054 nm. During regenerative amplification, an amplified output power of 38 W was obtained at repetition rates ranging from 50 to 200 kHz, the central wavelength of 1043 nm while a compressed pulse width of 290.8 fs. Benefiting from effective thermal management and the thermal insensitive cavity, a near-diffraction-limited beam quality was measured to be M
x
2 = 1.11 and M
y
2=1.11 at the highest output power.
27 August 2024 in High Power Laser Science and Engineering
We demonstrate efficient and economical all-solid-state post-compression based on dual-stage periodically placed thin fused silica plates driven by a more than 100 W ytterbium-doped yttrium aluminum garnet Innoslab amplifier seeded by a fiber frontend. Not only is a more than eight-fold pulse compression with 94% transmission achieved, but also the pulse quality and spatial mode are improved, which can be attributed to the compensation for the residual high-order dispersion and the spatial mode self-cleaning effect during the nonlinear process. It enables a high-power ultrafast laser source with 64 fs pulse duration, 96 W average power at 175 kHz repetition rates and good spatiotemporal quality. These results highlight that this all-solid-state post-compression can overcome the bandwidth limitation of Yb-based lasers with exceptional efficiency and mitigate the spatiotemporal degradation originating from the Innoslab amplifier and fiber frontend, which provides an efficient and economical complement for the Innoslab laser system and facilitates this robust and compact combination as a promising scheme for high-quality higher-power few-cycle laser generation.
30 June 2025 in Optics Express
We systematically investigate second-harmonic generation (SHG) in a lithium triborate (LBO) crystal by a femtosecond laser system (1030 nm, 195 fs, 30 W) with particular emphasis on back-conversion phenomena. For a selected 5 mm thick crystal, an optimal conversion efficiency of 54% is achieved at 18 W input power with beam quality factor M2 of 1.275 (horizontal) and 1.173 (vertical). Beyond the saturation threshold where back-conversion initiates, spectral broadening, temporal compression and beam quality deterioration emerge, accompanied by decreasing conversion efficiency. Increasing the beam diameter or reducing the crystal length effectively mitigates back-conversion phenomena. These findings establish valuable guidelines for optimizing the performance of femtosecond visible laser sources.