We report on the laser pulse output of 339 J centered at 800 nm from a chirped-pulse amplification (CPA) Ti:sapphire laser system at the Shanghai Superintense Ultrafast Laser Facility. The experimental results demonstrated that the parasitic lasing as well as the transverse amplified spontaneous emission of the homemade 235-mm-diameter Ti:sapphire final amplifier were suppressed successfully via the temporal dual-pulse pumped scheme and the index-matching liquid cladding technique. The maximum pump-to-signal conversion efficiency of 32.1% was measured for the final amplifier. With a compressor transmission efficiency of 64% and a compressed pulse duration of 21 fs obtained for the sample light at a lower energy level, this laser system could potentially generate a compressed laser pulse with a peak power of 10.3 PW. The experimental results represent significant progress with respect to the CPA laser.
Double deformable mirrors (DMs) with different actuator densities are cascaded to optimize the wavefront aberrations to improve the focus intensity of the Shanghai super-intense ultrafast laser facility (SULF), which plans to generate 10 PW laser pulse. The beam aberrations near the focal spot are corrected from 0.556 um to 0.112 um in RMS by a 300-mm DM with a large stroke installed after the compressor. After then, it is further optimized to 0.041 um using a 130-mm DM with a high spatial resolution working after the main amplifier. The corrected beam is focused to 2.75 × 2.87 um2 at the full width at half maximum (FWHM) with an f/2.5 off-axis parabolic mirror (OAP), which contains approximately 27.69% energy. A peak intensity of 2 × 1022 W/cm2 is achieved at the output of 5.4 PW, and it could exceed 1023 W/cm2 in the SULF 10 PW laser facility using an f/1.8 OAP.
We report the evolution of single-pulse and multi-pulse in a mode-locked all polarization-maintaining fiber laser based on a nonlinear optical loop mirror (NOLM). The main parameters of the laser were determined by numerically simulating the relationship between the number of pulses and the basic parameters of each element. Experiments demonstrate generation of 1 to 6 pulses per cavity round trip. There is an unstable regime between the stable N and N+1 pulses states when gradually increasing the pump power, while the intervals of the unstable regime shrink or even disappear when the direction of pump power variation is reversed. Our experimental results are different from those previously reported where the intervals of the unstable pulse regime are almost unchanged regardless of the pump power adjustment direction. We also describe how to obtain fundamental mode-locking from the multi-pulse state. The laser operated in the single-pulse regime shows excellent stability.
We demonstrate a 417 W, 175 kHz Innoslab chirped pulse amplification laser compressible to short and clean 406 fs pulse duration. A spectral bandwidth (full width at half maximum, FWHM) of ∼3 nm was maintained at full pump power, and the pulses exhibited good pulse quality in a wide tunable pulse energy range from 1.7 mJ to a maximum of 2.38 mJ. At the maximum output power, the compressed pulses were nearly pedestal free. The comprehensive effects of residual high-order dispersion from the front end, the gain shaping effects of the amplifier, and the slight mismatch of third-order dispersion (TOD) between the stretcher (CFBG) and the gating compressor, along with the small nonlinear phase shift accumulated in the amplifier, could have facilitated the high pulse quality. To the best of our knowledge, this is the shortest pulse duration from the Innoslab amplifiers at hundreds of watts average power in the millijoule energy regime.