To further increase the conversion efficiency of crystalline silicon (c-Si) solar cells, it is vital to reduce the recombination losses associated with the contacts. Therefore, a contact structure that simultaneously passivates the c-Si surface while selectively extracting only one type of charge carrier (i.e., either electrons or holes) is desired. Realizing such passivating contacts in c-Si solar cells has become an important research objective, and an overview and classification of work to date on this topic is presented here. Using this overview, we discuss the design guidelines for passivating contacts and outline their prospects.
1 September 2018 in Solar Energy Materials and Solar Cells
Surface passivation of germanium is vital for optimal performance of Ge based optoelectronic devices especially considering their rapidly increasing surface-to-volume ratios. In this work, we have investigated the surface passivation of Ge by a stack consisting of a thin layer of hydrogenated amorphous silicon (a-Si:H) and an aluminum oxide (Al2O3) capping layer. Plasma-enhanced chemical vapor deposition was used to deposit the a-Si:H (0–10 nm), while thermal and plasma-enhanced atomic layer deposition (ALD) were employed for the Al2O3 films (0–22 nm). Transient photoconductance decay measurements revealed a recombination velocity as low as 2.7 cm s−1 for an a-Si:H layer as thin as 1.8 nm and an Al2O3 film of only ∼6 nm. In this state-of-the-art passivation scheme, the plasma-enhanced ALD process for the Al2O3 capping layer proved superior to the thermal ALD process since it resulted in an exceptionally high negative fixed charge density (Qf∼ 1013 cm−2), which proved a key factor for the low surface recombination velocity. Transmission electron microscopy and energy x-ray dispersion revealed that a thin SiOx layer (∼1.4 nm) forms between a-Si:H and Al2O3 during the ALD process, which is thought to be the origin of this high negative fixed charge density. This passivation stack is regarded as highly interesting for applications such as solar cells, nanolasers, and nano-LEDs based on p-type Ge.
8 April 2014 in Solar Energy Materials and Solar Cells
The structural and electrical properties of metastable defects in various types of hydrogenated amorphous silicon have been studied using a powerful combination of continuous wave electron-paramagnetic resonance spectroscopy, electron spin echo (ESE) decay measurements, and Doppler broadening positron annihilation spectroscopy. The observed dependence of the paramagnetic defect density on the Doppler parameter indicates that porous, nanosized void-rich materials exhibit higher spin densities, while dense, divacancy-dominated materials show smaller spin densities. However, after light soaking more similar spin densities are observed, indicating a long-term defect creation process in the Staebler-Wronski effect that does not depend on the a-Si:H nanostructure. From ESE decays it appears that there are fast and slowly relaxing defect types, which are linked to various defect configurations in small and large open volume deficiencies. A nanoscopic model for the creation of light-induced defects in the a-Si:H nanostructure is proposed.
1 September 2012 in Journal of Non-Crystalline Solids