2 April 2021 in IEEE Transactions on Instrumentation and Measurement
Transmission line parameters vary with environmental and operating conditions, thus introducing uncertainties in power flow studies and protection zone settings of relay protection equipment. Variations of line parameters are fundamental for the determination of static and dynamic line power ratings. Usually, nominal values are given without an associated confidence interval, and therefore an important piece of information is missing. With the proliferation of phasor measurement units (PMUs) that allows for synchronized measurements at different geographical positions, arouse the possibility for simple and efficient measurements of line parameters. This article analyzes uncertainties associated with the estimation of line parameters, based on the equivalent π model, valid for short and medium length transmission lines. This problem has been addressed in literature, but only from a theoretical perspective and obtained results were verified with simulations only. Here, measurements conducted on two 220 kV transmission lines are analyzed. It was found that correlation between voltage and current measurements must be taken into consideration when analyzing uncertainty propagation law. Only then statistical analysis of estimations match predictions obtained by applying the theoretical model. Accuracy limits were analyzed as well, but in this case some results were within calculated limits, while others did not follow predictions. Improvements in accuracy limits determination require the separation of environmental and operating condition variations from deviations due to measurement equipment, thus requiring additional information.
23 October 2024 in European Conference on e-Learning
In recent years, the problem of the number of students enrolled in STEM courses falling below the minimum required to carry out the courses has worsened. This situation, which used to occur primarily in degree programs at the end of their life cycle, is increasingly happening in active STEM degree programs as well. The declining attractiveness of traditional STEM degree programs and negative demographic trends are seen as the main causes of this problem. To assist students and their teachers in this situation, a novel approach to grading student work based on the level at which students achieve learning outcomes in an online system was explored. Since the focus was on STEM students, math-based tasks were used to assess student knowledge within the online system. In addition to the accuracy of the final results of the tasks, the accuracy of the intermediate results was also monitored. Each result was linked to the corresponding concepts, which in turn were linked to the corresponding learning outcomes. By entering correct intermediate and final results, the online system was able to monitor student success in mastering concepts and learning outcomes. The implemented online system utilizes fuzzy inference to calculate the levels at which students have achieved the learning outcomes. These levels are continuously recalculated during the semester and presented to the students through generated recommendations after each solved task. The proposed approach has positively impacted students’ motivation to learn during the semester, as confirmed by an anonymous questionnaire. Additionally, the results have shown that the final level at which students have achieved the learning outcomes within the online system, calculated at the end of the semester, can be used for grading and is comparable to the grades students would achieve in traditional midterm and final exams, thus helping teachers with their workload.