4 June 2021 in IEEE Transactions on Power Electronics
In this article, a dual active bridge (DAB)-LLC-DCX dc-dc converter with integrated magnetics and shared rectifier is proposed for point of load applications, which is able to achieve tight voltage regulation, zero-voltage switching (ZVS) operation for all switches and zero-current switching operation for rectifier. The challenge of the proposed converter is the realization of ZVS operation for all the switches within full power range to achieve high efficiency and high reliability, which is beneficial for light load efficiency improvement of microprocessors. Therefore, with different input voltage range, a hybrid control strategy is proposed to realize ZVS operation for all switches of the proposed converter within full power range in this article. When at high input voltage, extended phase shift control is applied to extend the ZVS range. When at low input voltage, variable gain LLC converter is designed to regulate the voltage distribution among DAB converter and LLC converter for the ZVS operation of DAB converter. Besides, the charging/discharging of junction capacitors are added into consideration of ZVS analysis. The operating principle, design considerations, and control schemes are presented. Finally, the experimental results of an 80-W prototype verified the theoretical analysis.
13 April 2022 in IEEE Transactions on Power Electronics
The dc power distribution has become a promising solution to powering datacenters, which can reduce power conversion steps and total power losses. However, both of the two most promising options, 380 V and 48 V dc power distributions, have their own defects that cannot be ignored, such as 380 V dc power distributions have lower reliability and 48 V dc power distributions have lower efficiency. In this article, a three-port LCC resonant converter is proposed to eliminate the above-mentioned defects by combining the aforementioned dc distributions to form a 380-V/48-V hybrid dc system. A full-bridge LCC converter is used to transfer power to the 380 V load, whereas a bidirectional LCC converter is used to charge the 48-V battery packs, and the two are magnetically coupled by a three-port transformer. The converter realizes zero-voltage switching of all switches and zero-current switching of rectifying diodes through resonance. The battery charging current is controlled by changing the frequency of all switches to achieve the switch of constant-current charging and constant-voltage charging, and the phase-shift control is adopted to keep the output voltage constant. Simulations and experiments are carried out to verify the validity of the theory.
19 February 2021 in IEEE Journal of Emerging and Selected Topics in Power Electronics
In this article, a current-sharing method for interleaved high-frequency LLC converter with partial energy phase shift regulation is presented. An auxiliary low-power converter is added in each phase, which is able to achieve natural current sharing and the zero-voltage switching (ZVS) operation for the auxiliary circuit. Meanwhile, the perfect current sharing between phases is achieved by controlling the phase shift angle between the LLC bridge and the auxiliary bridge. Only partial energy is processed by the auxiliary converter; hence, the power losses of the added auxiliary converters are minimized, and the overall high efficiency is maintained. By transforming the current sharing of the resonant converter into phase shift control between the LLC bridge and the auxiliary bridge, the proposed method is simple to implement and easy to extend to multiple phases. The frequency of the auxiliary converter is the same as that of of the main LLC converter, so it is suitable to operate the auxiliary circuit at a high switching frequency to improve the power density. The operating principle, design considerations, and the control schemes are presented, and a 400-kHz two-phase interleaved LLC prototype was built to verify the theoretical analysis.
21 September 2021 in IEEE Transactions on Power Electronics
To realize a soft-switching inverter with small volume and high efficiency, a synchronous auxiliary resonant commutated pole (SARCP) soft-switching inverter with improved load adaptability is proposed, which only contains two auxiliary inductors. In one switching cycle, all commutation processes can be synchronously assisted by an auxiliary inductor. Soft switching is achievable for all switches of the SARCP inverter. Compared with the auxiliary resonant commutated pole (ARCP) inverter, the SARCP inverter has improved load adaptability, especially in the light load current condition, which is beneficial to reduce the total power loss and the dc-link capacitance. The equivalent circuits of the SARCP inverter are given under different operation modes. The operation principle, soft-switching implementation conditions, parameter optimization design methods, and the characteristics of the SARCP inverter are analyzed. Finally, simulation and experimental results verify the effectiveness of the SARCP inverter.
30 October 2020 in IEEE Transactions on Power Electronics
Single-phase single-stage non-isolated photovoltaic grid-tied inverters mainly suffer from issues of common-mode leakage current and double-line-frequency power oscillation. Aiming at above issues, this paper designs a new single-phase photovoltaic grid-tied inverter with only two switches. The proposed inverter structure allows the neutral line of the AC grid directly connected to the negative pole of the photovoltaic panel so that the common-mode leakage current is completely eliminated. Additionally, a power decoupling method is proposed to suppress the double-line-frequency power oscillation. Then an improved control strategy is presented in this paper to solve the stability problem of the proposed inverter when it is connected to a weak grid. It should be noted that the designed inverter can also output reactive power, achieve zero-voltage switching, track maximum power point, and step up the output voltage. The validity of the proposed inverter and improved control strategy is verified by simulation and experiment results.
27 July 2021 in IEEE Transactions on Power Electronics
This article proposed a grid-connected photovoltaic (PV) converter based on modular multilevel converter (MMC), which can realize long-distance dc transmission while realizing the local consumption of PV. In addition to the advantage that there is no PV power mismatch between the upper and lower arms, the isolation transformer couples the two submodules of the upper and lower arms on a three-port transformer, and the differential-mode components of the capacitor voltage ripples in the upper and lower arms can be canceled between each other. Besides, through the double fundamental frequency circulating current control, the power exchange among MMC phase units can be realized, thereby eliminating the common-mode component of the capacitor voltage ripple. Through the combination of topology and control strategy, the low-frequency components of the voltage ripple can be completely canceled. Since the decoupling capacitance is reduced dozens of times, the volume and cost of the system are significantly reduced. Therefore, the life and reliability of the system are increased. Simulation and experimental results verify the effectiveness of the proposed topology and its control strategy.