Shangzhi Pan

Shangzhi Pan

Auto-generated profile, based on publicly available information

Shangzhi Pan

Hubei Key Laboratory of Power Equipment and System Security for Integrated Energy, School of Electrical Engineering and Automation, Wuhan University, Wuhan, China

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 February 2019 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
JJJianbo Jiang
Jianbo Jiang
FLFei Liu
Fei Liu
SPShangzhi Pan
Shangzhi Pan
XZXiaoming Zha
Xiaoming Zha
WLWenjun Liu
Wenjun Liu
LHLidong Hao
Lidong Hao
Large disturbance scenarios such as pulse power load operation and load switching are commonly seen in the operation of DC microgrids. The mixed potential theory-based large-signal stability (LSS) analysis is a simple and practical method for investigating the LSS of DC microgrids. However, this method is characterized by conservatism, and produces conservative stability criterion results. When they are applied to the parameter designs of DC microgrids, they create excessive control parameter redundancies; when used for running status estimations, they may cause the system to be misjudged as unstable, and trigger unnecessary protective actions when the system runs into the conservative region. This paper presents a comprehensive analysis of the conservatism, revealing its main causes to be the idealization of the load converter's response characteristics, and the lack of refined models. It then proposes a novel, improved analysis method for transient response characteristics of the load converter. Experimental and simulation results using the improved method have validated it by showing that the conservatism of the traditional method had been eliminated, and the stability criterion obtained was more accurate.

25 February 2022 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
XFXikun Fu
Xikun Fu
MHmeng huang
meng huang
SPShangzhi Pan
Shangzhi Pan
XZXiaoming Zha
Xiaoming Zha
In this letter, a cascading synchronization instability phenomenon is reported in a multi-voltage-source-converter (VSC) grid. By adopting the equal area criterion, it is revealed that during the fault transient, there is static interaction that increases equivalent mechanical power for the original stable-operating VSC. Due to the fast power angle swing of the unstable VSC, there is nonnegligible dynamic interaction, which may decrease its synchronization stability margin. The effect of system parameters on synchronization stability is studied, and the simulation and experimental results verify the analysis.

2 December 2020 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
YZYizhan Zhuang
Yizhan Zhuang
FLFei Liu
Fei Liu
YHYanhui Huang
Yanhui Huang
ZLZhouyang Liu
Zhouyang Liu
SPShangzhi Gae Pan
Shangzhi Gae Pan
JJJianbo Jiang
Jianbo Jiang
An input-independent and output-series (IIOS) modular DC-DC converter with multiple input ports and high voltage conversion ratio can apply well to medium-voltage DC (MVDC) interface of distributed photovoltaics (PV). However, PV power mismatch will result in output voltage imbalance of the submodules (SMs), which is contrary to the standardized multi-module design. In this paper, a multiport modular DC-DC converter with low-loss series LC power balancing unit (PBU) is proposed to address this problem. An isolated DC-DC converter is employed as the SM, which consists of full-bridge (FB) circuit on the PV side and half-bridge (HB) circuit on the grid side. Independent maximum power point tracking (MPPT) can be realized by controlling the phase shift between the FB and the HB, while voltage balancing (or power balancing) of SMs can be achieved by regulating the phase shift between adjacent HBs. Only one inductor and one capacitor are used in the PBU and all the switches of SM turn on with zero-voltage switching (ZVS), which contributes to the low-cost and low-loss characteristic of the converter. Simulations and experiments are carried out to verify the validity of the theory.

18 August 2021 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
YZYizhan Zhuang
Yizhan Zhuang
FLFei Liu
Fei Liu
YHYanhui Huang
Yanhui Huang
SWShiwen Wang
Shiwen Wang
SPShangzhi Pan
Shangzhi Pan
XDXiaoguang Diao
Xiaoguang Diao
In the traditional dc distribution networks with both a low-voltage dc (LVdc) and a medium-voltage dc (MVdc) bus, dc units, such as photovoltaics solar, storage devices, and dc loads, are connected to the LVdc bus through LVdc converters, such as dc/dc boost converters and bidirectional buck–boost dc/dc converters. In this approach, no galvanic isolation is provided and two power conversion stages are needed between the dc units and the MVdc grid, hence leading to a high number of converters and higher costs. To address these shortcomings, this article proposes a novel multiport dc solid-state transformer (MDCSST) to interface these dc units directly to the MVdc bus. Multiple modules are connected in series on the medium-voltage side to the MVdc bus, whereas dc units are independently connected on the low-voltage side of the MDCSST. Compared with a traditional dc distribution network, the proposed scheme connects dc units to the MVdc bus without an extra converter or an LVdc bus, therefore, saving cost and reducing the number of converters. In addition, dc units are galvanically isolated by high-frequency transformers. The main challenge of the MDCSST is to resolve the voltage-imbalance problem on the MVdc side, which is caused by the dc units’ power differences. An LC branch is used to balance the voltages among the modules and to transfer their differential powers. Simulations and experiments were carried out to validate the proposed approach and verify the theoretical analysis.

4 June 2021 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
MWMinglong Wang
Minglong Wang
SPShangzhi Pan
Shangzhi Pan
XZXiaoming Zha
Xiaoming Zha
JGJinwu Gong
Jinwu Gong
WLWenqiang Lin
Wenqiang Lin
QDQipeng Deng
Qipeng Deng
In this article, a dual active bridge (DAB)-LLC-DCX dc-dc converter with integrated magnetics and shared rectifier is proposed for point of load applications, which is able to achieve tight voltage regulation, zero-voltage switching (ZVS) operation for all switches and zero-current switching operation for rectifier. The challenge of the proposed converter is the realization of ZVS operation for all the switches within full power range to achieve high efficiency and high reliability, which is beneficial for light load efficiency improvement of microprocessors. Therefore, with different input voltage range, a hybrid control strategy is proposed to realize ZVS operation for all switches of the proposed converter within full power range in this article. When at high input voltage, extended phase shift control is applied to extend the ZVS range. When at low input voltage, variable gain LLC converter is designed to regulate the voltage distribution among DAB converter and LLC converter for the ZVS operation of DAB converter. Besides, the charging/discharging of junction capacitors are added into consideration of ZVS analysis. The operating principle, design considerations, and control schemes are presented. Finally, the experimental results of an 80-W prototype verified the theoretical analysis.

13 April 2022 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
ZLZisen Lin
Zisen Lin
SPShangzhi Pan
Shangzhi Pan
MWMinglong Wang
Minglong Wang
WLWenqiang Lin
Wenqiang Lin
JGJinwu Gong
Jinwu Gong
PJPraveen Jain
Praveen Jain
The dc power distribution has become a promising solution to powering datacenters, which can reduce power conversion steps and total power losses. However, both of the two most promising options, 380 V and 48 V dc power distributions, have their own defects that cannot be ignored, such as 380 V dc power distributions have lower reliability and 48 V dc power distributions have lower efficiency. In this article, a three-port LCC resonant converter is proposed to eliminate the above-mentioned defects by combining the aforementioned dc distributions to form a 380-V/48-V hybrid dc system. A full-bridge LCC converter is used to transfer power to the 380 V load, whereas a bidirectional LCC converter is used to charge the 48-V battery packs, and the two are magnetically coupled by a three-port transformer. The converter realizes zero-voltage switching of all switches and zero-current switching of rectifying diodes through resonance. The battery charging current is controlled by changing the frequency of all switches to achieve the switch of constant-current charging and constant-voltage charging, and the phase-shift control is adopted to keep the output voltage constant. Simulations and experiments are carried out to verify the validity of the theory.