6 October 2016 in Microsystem Technologies
24 June 2021 in ACS Omega
Constructing hybrid energetic materials (HEMs) consisting of nanothermites and organic high explosives is an efficient strategy to regulate the reactivity of energetic composites. To investigate the role of interfacial microstructures in determining the reactivity of HEMs, we employ electrospray, one ramification of electrohydrodynamic atomization, to assemble Al/CuO and hexanitrohexaazaisowurtzitane (CL-20) into composites with various morphologies from different solvent systems. The morphology and compositional information of the assembled clay-like or granular HEMs, which are obtained from ketone, ester, or mixtures of alcohol and ether, are confirmed by scanning electron microscopy (SEM) and energy-dispersive X-ray spectroscopy (EDS). The phase transition of CL-20 due to the fast evaporation of charged droplets and insufficient time for recrystallization is studied by Fourier transform infrared spectroscopy (FTIR). Thermogravimetric-differential scanning calorimetry (TG-DSC) is applied to investigate the thermodynamic behaviors and synergistic effect of the nanothermite and high explosive. Enhancements in combustion performance and pressurization characteristics of the as-sprayed HEMs have been observed through open burn tests and pressure cell tests. Granular HEMs show high gas generation and high pressurization rate, while nitrocellulose (NC) fibers existing in the clay-like HEMs would weaken the reactivity to a certain extent. HEMs obtained from the mixture of n-propanol and diethyl ether, in which nano-CL-20 exists as independent particles rather than a matrix, exhibit high gas generation but low pressurization rate. The results indicate that the energy releasing performance of the prepared HEMs can be readily regulated by constructing various interfacial microstructures to satisfy the broad requirements of energy sources.
15 March 2017 in Journal of Applied Physics
Three types of energetic semiconductor bridges (ESCBs) through integrating different Al/MoOx energetic multilayer nanofilms on a semiconductor bridge have been investigated in this study. The relationships among the critical firing energy, critical firing time, total firing time, and ignition energy as well as the input energy utilization efficiency of these initiators were analyzed. The principal component analysis (PCA) was utilized in the experiments to evaluate the output energy magnitude based on the ignition duration, the maximum flame area, reaction ratio, and other parameters. The results obtained were as follows: (1) The critical firing energy is positively proportional to the modulation periods of nanofilms for the initiators discharged with identical voltage, while the total firing energy and the input energy utilization efficiency do not change significantly; (2) by using PCA, the composite score of the ESCB/50 nm, ESCB/150 nm, ESCB/1500 nm, and SCB is measured at 3.025, 0.250, −1.433, and −1.842, respectively, discharge with 30 V/47 μF, which indicated that the output energy of ESCBs can be increased significantly by decreasing the modulation periods of nanofilms.