16 November 2015 in Nature Nanotechnology
2 December 2015 in Nanoscale
Ferroelectric nanocantilevers function as switchable “strain diodes”: their electromechanical response is enhanced when ferroelectricity and flexoelectricity are parallel, and diminished or even suppressed when they are antiparallel.
9 November 2020 in Physical Review Research
We study the potential of all-electrical inductive techniques for the spectroscopy of propagating forward volume spin waves. We develop a one-dimensional model to account for the electrical signature of spin-wave reflection and transmission between inductive antennas and validate it with experiments on a perpendicularly magnetized Co/Ni multilayer. We describe the influence of the antenna geometry and antenna-to-antenna separation, as well as that of the material parameters on the line shape of the inductive signals. For a finite damping, the broadband character of the antenna emission in the wave vector space imposes to take into account the growing decoherence of the magnetization waves on their spatial propagation. The transmission signal can be viewed as resulting from two contributions: A first one from propagating spin-waves leading to an oscillatory phase of the broadband transmission coefficient and another one originating from the distant induction of ferromagnetic resonance because of the long-range stray fields of realistic antennas. Depending on the relative importance of these two contributions, the decay of the transmitted signal with the propagation distance may not be exponential and the oscillatory character of the spin-wave phase on propagation may be hidden. Our model and its experimental validation allow us to define geometrical and material specifications to be met to enable the use of forward volume spin waves as efficient information carriers.
4 November 2011 in Journal of Materials Research
EEEnrique Escobedo-Cousin
+1
16 January 2020 in Journal of Applied Physics
We compare the characteristics of electrically transduced Damon–Eshbach spin-wave (DESW) and backward volume spin-wave (BVSW) configurations within the same, 30 nm thick, ferromagnetic, CoFeB waveguide. Sub-micrometer U-shaped antennas are used to deliver the necessary in-plane and out-of-plane RF fields. We measure the spin-wave transmission with respect to in-plane field orientation, frequency, and propagation distance. Unlike DESW, BVSWs are reciprocally transduced and collected for either direction of propagation, but their ability to transport energy is lower than DESWs for two reasons. This arises first because BVSWs are inductively transduced less efficiently than DESWs. Also, in the range of wavevectors (∼5 rad μm−1) typically excited by our antennas, the group velocity of BVSWs stays lower than that of DESW, which leads to reduced propagation ability that impact transmission signals in an exponential manner. In contrast, the group velocity of DESWs is maximum at low fields and decreases continuously with the applied field. The essential features of the measured SW characteristics are well reciprocated by a simple, 1D analytical model, which can be used to assess the potential of each configuration.
21 January 2013 in Applied Physics Letters
The piezo-resistance of 100 nm-thick, [110] oriented, p-type, mono-crystalline Si beams has been investigated under large uniaxial tension up to 2 GPa using an original on-chip tensile testing set-up. The piezo-resistance coefficient (π) was found to increase by a factor of 6 compared with ∼1.5 for Si bulk, when decreasing the dopant concentration from Na ∼ 1 × 1019 cm−3 down to Na ∼ 5 × 1017 cm−3. Reduction of resistance by a factor of 5.8, higher than theoretical maximum of 4.5, is reported for Na ∼ 5 × 1017 cm−3 under a stress of 1.7 GPa, without any sign of saturation.