15 May 2024 in IEEE Transactions on Power Electronics
Fast and reliable protection against short-circuit (SC) faults is critically important for the reliable operation of power devices. In this letter, an ultrafast and universal short-circuit protection (SCP) method is proposed for silicon carbide metal–oxide–semiconductor field-effect transistors based on gate current detection. This method exploits the characteristic of the gate current to become negative during SC faults and constant positive during normal operation. The proposed gate current detection approach swiftly identifies faults during the SC process, ensuring rapid response time. In addition, this method boasts broad applicability, being effective for both hard switching faults (HSFs) and faults under loads (FULs), and no extra auxiliary design is required for the three-pin device. The efficacy of the proposed SCP technique is validated through the testing of the SCP circuit. Experimental results demonstrate that the proposed circuit is applicable to both HSFs and FULs, with response delays of 69 ns for HSFs and 50 ns for FULs, and total protection trigger time of 383 ns for HSFs and 352 ns for FULs.
28 November 2022 in IEEE Transactions on Electron Devices
In this work, a novel shallow oxide trench (SOT) shorted-anode (SA) silicon-on-insulator (SOI) lateral insulated-gate bipolar transistors (LIGBTs) with an adaptive electron channel (AEC) in anode is proposed and investigated by numerical simulations. The AEC is controlled by a polysilicon electrode on the right side of the device and connected to anode, while an SOT and a P $+$ area are used to separate the P $+$ anode and N $+$ anode. At low anode voltage ( $\textit{V}_{\textit{A}}$ ), the AEC shows strong resistance to electrons, resulting in the N $+$ anode to be blocked. Once a high $\textit{V}_{\textit{A}}$ is applied, the channel will open allowing electrons to flow through. On this basis, the device can achieve low forward voltage drop ( $\textit{V}_{\biosc{on}}$ ) and reduce the turn-off loss ( $\textit{E}_{\biosc{off}}$ ) without snapback effect. Compared to separated SA LIGBT (SSA LIGBT), a much smaller dimension of cell pitch with enhanced performance is achieved in this new structure. The simulation results demonstrate that $\textit{V}_{\biosc{on}}$ reduces by 28.4% under the same $\textit{E}_{\biosc{off}}$ and $\textit{E}_{\biosc{off}}$ reduces by 28.0% under the same $\textit{V}_{\biosc{on}}$ when compared to conventional (Conv.) LIGBT. Moreover, further simulations on the safe operating area (SOA) reveal that the proposed structure possesses better reliability than the SSA LIGBT.
23 December 2024 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Short-circuit (SC) robustness is an important concern for power devices in switching mode power supplies. For individual transistors such as Si and SiC MOSFETs, the SC capability has been widely reported. However, for the cascode GaN High electron mobility transistor (HEMT), which consists of a Si MOSFET and a depletion-mode HEMT(DHEMT), the inside mechanisms of SC have not been fully investigated yet. In this article, by setting two individual devices, both experiments and numerical simulations are performed to reveal the electrothermal failure mechanisms of cascode GaN HEMTs during SC operation. The electrical characteristics for the Si MOSFET and the DHEMT are separately extracted. It is confirmed that the DHEMT withstands a much higher electrothermal stress than the Si MOSFET during SC operation. Thermal failures tend to occur in the DHEMT. Furthermore, thermal and mechanical simulations are deployed to analyze the failure mechanism within DHEMT structure. The thermal induced mechanical stress due to different thermal expansion rates of heterojunction layers is the source of failure. Finally, an analysis is conducted on the unique gate control mechanism that limits the SC capability of the cascode configuration. A design guidance is proposed for tradeoff relationship between SC robustness and device on-resistance in cascode GaN HEMT.
1 November 2026 in IEEE Transactions on Power Electronics
SiC MOSFETs require ultra-fast short-circuit (SC) protection because of their limited SC withstand time. However, most existing indirect SC detection methods rely on instantaneous electrical quantities and are therefore vulnerable to switching noise. This letter proposes a unified SC protection method based on Kelvin-source disturbance charge integration. By rectifying and integrating the disturbance current coupled into the Kelvin-source path, the proposed method suppresses short switching spikes while preserving sensitivity to sustained SC disturbances. Thus, both hard-switching fault (HSF) and fault under load (FUL) can be identified using the same detection variable and the same threshold-based criterion. Experimental results demonstrate detection times of 90-96 ns and total protection times of 400-407 ns, without additional power-loop sensors and with strong potential for compact gate-driver integration.