9 June 2014 in Applied Physics Letters
The stability of valley polarized electron states is crucial for the development of valleytronics. A long relaxation time of the valley polarization is required to enable operations to be performed on the polarized states. Here, we investigate the stability of valley polarized states in diamond, expressed as relaxation time. We have found that the stability of the states can be extremely long when we consider the electron-phonon scattering processes allowed by symmetry considerations. We determine electron-phonon coupling constants by Time-of-Flight measurements and Monte Carlo simulations and use these data to map out the relaxation time temperature dependency. The relaxation time for diamond can be microseconds or longer below 100 K and 100 V/cm due to the strong covalent bond, which is highly encouraging for future use in valleytronic applications.
1 November 2020 in Advanced Theory and Simulations
A method based on the scaling properties of the Boltzmann transport equation is proposed to identify the dominant scattering mechanisms that affect charge transport in a semiconductor. This method uses drift velocity data of mobile charges at different lattice temperatures and applied electric fields and takes into account the effect of carrier heating. By performing time‐of‐flight measurements on single‐crystalline diamond, hole and electron drift velocities are measured under low‐injection conditions within the temperature range 10–300 K. Evaluation of the data using the proposed method identifies acoustic phonon scattering as the dominant scattering mechanism across the measured temperature range. The exception is electrons at 100–200 K where conduction‐band valley repopulation has a prominent effect. At temperatures below ≈80 K, where valley polarization is observed for electrons, transport dominated by acoustic phonon scattering is observed in different valleys separately. The scaling model is additionally tested on data from highly resistive gallium arsenide samples to demonstrate the versatility of the method. In this case, impurity scattering can be ruled out as the dominant scattering mechanism in the samples for the temperature range 80–120 K.
10 October 2006 in Advances in Science and Technology
1 July 1996 in Optics Communications
1 June 2019 in Review of Scientific Instruments
Full investigation of deep defect states and impurities in wide-bandgap materials by employing commercial transient capacitance spectroscopy is a challenge, demanding very high temperatures. Therefore, a high-temperature deep-level transient spectroscopy (HT-DLTS) system was developed for measurements up to 1100 K. The upper limit of the temperature range allows for the study of deep defects and trap centers in the bandgap, deeper than previously reported by DLTS characterization in any material. Performance of the system was tested by carrying out measurements on the well-known intrinsic defects in n-type 4H-SiC in the temperature range 300–950 K. Experimental observations performed on 4H-SiC Schottky diodes were in good agreement with the literature. However, the DLTS measurements were restricted by the operation and quality of the electrodes.
23 May 2016 in Applied Physics Letters
The recent discovery of Negative Differential Mobility (NDM) in intrinsic single-crystalline diamond enables the development of devices for high frequency applications. The Transferred-Electron Oscillator (TEO) is one example of such devices that uses the benefit of NDM to generate continuous oscillations. This paper presents theoretical investigations of a diamond TEO in the temperature range of 110 to 140 K where NDM has been observed. Our simulations map out the parameter space in which transferred-electron oscillations are expected to occur for a specific device geometry. The results are promising and indicate that it is possible to fabricate diamond based TEO devices.