The highest efficiency of 4.225% for vapor-transport-deposited (VTD) SnS absorber/CdS heterojunction solar cells with good long-term stability over two years is reported. These improved characteristics are attributed to the reduction in interface defects of the heterojunction, which can occur either during the deposition of transparent electrodes or direct annealing of the SnS/CdS heterojunction at 300 °C. The enhanced heterojunction interface quality is supported by the substantially reduced dark saturation current density and shunt conductance of the fabricated devices measured under dark conditions. Although the SnS/CdS device exhibits efficiency over 4%, significant short-circuit current loss mainly due to recombination was revealed by quantum efficiency and optical analysis. Admittance analysis shows the presence of numerous defect densities of Sn and S vacancies (>1017 cm−3) in the VTD-grown SnS absorber. Minimizing bulk and interface defect densities of SnS absorbers will be a key issue in achieving high efficiency (>5%) of SnS-based thin-film solar cells.
Monolithically integrated, 2-terminal CuInSe2–perovskite tandem solar cells are successfully fabricated using low-cost solution processes, demonstrating higher efficiency than the constituent single-junction devices.
Tandem architecture between organic (dye-sensitized solar cell, DSSC) and inorganic (CuInGaSe2thin film solar cell, CIGS) single-junction solar cells was constructed particularly based on a solution process. Arc-plasma deposition was employed for the Pt interfacial layer to minimize the damage to the layers of the CIGS bottom cell. Solar cell efficiency of 13% was achieved, which is significant progress from individual single-junction solar cells (e.g., 7.25 and 6.2% for DSSC and CIGS, respectively).
Cu 2 ZnSnS 4 synthesized by a solvent-free mechanochemical process were successfully applied to fabricate Cu 2 ZnSnSe 4 solar cells with efficiencies over 6%.