Department of Chemical Engineering, Clean Energy Institute, Molecular Engineering and Sciences Institute, University of Washington, Seattle, Washington 98195-1750, USA
Auto-generated profile, based on publicly available information
Yuhuan Meng
Department of Chemical Engineering, Clean Energy Institute, Molecular Engineering and Sciences Institute, University of Washington, Seattle, Washington 98195-1750, USA
The practicality and economic viability of hybrid perovskite (HP) solar cells hinges on their operational lifetime, and methods to forecast the performance of perovskites under different operational stresses are greatly needed. Here, we explore the evolution of material-level optoelectronic properties as MAPbI3 degrades and discover universal behaviors where the carrier diffusion length (LD) decays before quasi-Fermi level splitting (∆EF), regardless of specific stress protocol (oxygen, humidity, thermal stress, or combination). We employ a machine learning greedy feature selection model that uses initially measured properties to predict the time it takes LD to fall to 85% of its initial value with prediction accuracy of 12.8%. This model reveals a strong correlation between the initial rate of transmittance change and the time until loss of transport. We translate this material-level finding to photovoltaic device-level forecasting by demonstrating that the rate of change of transmittance is equivalent to the rate of change of the spatial standard deviation of dark-field (DF) image intensity (i.e. scattered light intensity) collected in reflection mode (and thus applicable to devices with opaque contacts). This work demonstrates that transmittance and scattering methods are highly effective for accelerated material (and device) stability evaluation and forecasting.
11 February 2019 in ACS Applied Materials & Interfaces
The kinetics of light-induced Pb 0 formation in mixed-cation, mixed-halide perovskite films are studied using sub-bandgap absorption measurements. Oxygen is shown to prevent Pb 0 formation and modulate the optoelectronic performance decline.
Bismuth triiodide is a lead-free direct wide-bandgap solution-processable semiconductor that could be an alternative to lead-based perovskites in tandem or multijunction solar cells. However, the power conversion efficiency of single-junction BiI3 solar cells remains low. Here, we determine the main loss mechanisms of BiI3 solar cells in both n-i-p and p-i-n architectures. Overall, p-i-n devices have higher power conversion efficiency than that of n-i-p. It is found that n-i-p devices have higher (and significant) non-radiative recombination at the interface of the BiI3/transport layer, resulting in a lower open-circuit voltage than p-i-n devices. Moreover, the high series resistance (>70 Ω cm2) and a low average electron–hole diffusion length (∼60 nm) contributes to the low short-circuit current density (<5 mA/cm2) and fill factor (<40%) in all devices. In addition, interface recombination also reduces short-circuit current density. Finally, we demonstrate that lithium doping of BiI3 can increase the diffusion length of BiI3 to improve the performance of BiI3 solar cells. Solar cells with the configuration ITO/NiOx/Li:BiI3/PC61BM/bis-C60/LiF/Ag obtain a power conversion efficiency of 1.3% under AM 1.5 G illumination. The deep understanding of the main loss mechanisms of this work paves the way for future optimization of BiI3 solar cells.