Dion Li

Dion Li

Auto-generated profile, based on publicly available information

Dion Li

Department of Nuclear Engineering and Radiological Sciences, University of Michigan 1 , Ann Arbor, Michigan 48109, USA

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 August 2021 in IEEE Transactions on Plasma Science
Verified
Journal Article
Open access
YLY. Y. Lau
Y. Y. Lau
DPDrew A. Packard
Drew A. Packard
CSChristopher J. Swenson
Christopher J. Swenson
JLJohn W. Luginsland
John W. Luginsland
DLDion Li
Dion Li
RGRonald M. Gilgenbach
Ronald M. Gilgenbach
This article re-examines the Brillouin flow solutions in crossed-field diodes, with applications to magnetrons, magnetically insulated line oscillators (MILOs), and magnetically insulated transmission lines (MITLs). The Brillouin flow solutions are constructed for various geometries, including planar magnetrons, MILOs, and MITLs, cylindrical magnetrons with electrons flowing in the azimuthal direction, cylindrical MITLs and MILOs with electrons flowing in the axial direction, and radial MITLs and MILOs with electrons flowing in the radial direction. A common theme of this analysis is that two main external parameters are used to characterize the Brillouin flow: the anode–cathode voltage ( $V_{a}$ ) and the total magnetic flux within the crossed-field diodes ( $A_{a}$ ). These two parameters are equivalent to the gap voltage and a specification of the degree of magnetic insulation, which is approximately equal to the ratio of the magnetic field to the Hull cutoff (HC) magnetic field. The magnetic flux may be provided externally by a magnet (as in a magnetron) or by the wall currents without an external magnet (as in a MILO or MITL), or by some combination of the two, as in the intermediate case of a magnetron–MILO hybrid. Once these two parameters are specified, the electron flow speed at the top of the Brillouin hub is uniquely determined. This immediately yields the Buneman–Hartree (BH) condition according to the Brillouin flow model, whether it be a planar magnetron or a cylindrical MILO. In so doing, we have obtained, for the first time using the Brillouin flow model, the BH condition for a cylindrical MILO, and we show that the same condition is obtained from the single-particle orbit model. We also found that, in general, the electron current within the Brillouin hub contributes only to a very small fraction of the magnetic flux $A_{a}$ , regardless of the gap voltage $V_{a}$ , thereby correcting an erroneous notion that the electron flow within the crossed-field gap could be responsible for the magnetic insulation. Another counter-intuitive finding is that, for a given degree of magnetic insulation, the Brillouin hub height decreases as the gap voltage $V_{a}$ increases. These conclusions, and other results, were based on the simple, explicit analytic expressions that we have obtained for the Brillouin flow profiles, including the velocity, electron density, as well as the self-magnetic field and the self-electric field profiles due to the Brillouin hub electrons. From these analytical expressions, we deduce useful scaling laws that are applicable to the prevailing cases where the magnetic field exceeds 1.5 times the HC magnetic field, and they are valid in both relativistic and non-relativistic regimes. Thus, these scaling laws show the contrast between magnetrons and MILOs, and a ready assessment of the viability of building a moderate-current MILO, a low-voltage MILO, and a magnetron–MILO hybrid which might combine the advantages of a magnetron and a MILO. The Brillouin flow profiles in a radial MITL are explicitly calculated. Additional issues are addressed.

1 September 2023 in Physics of Plasmas
Verified
Journal Article
Open access
PDF file
YLY. Y. Lau
Y. Y. Lau
DLDion Li
Dion Li
DCDavid P. Chernin
David P. Chernin
We consider the limiting current from an emitting patch whose size is much smaller than the anode–cathode spacing. The limiting current is formulated in terms of an integral equation. It is solved iteratively, first to numerically recover the classical one-dimensional Child–Langmuir law, including Jaffe's extension to a constant, nonzero electron emission velocity. We extend to two-dimensions in which electron emission is restricted to an infinitely long stripe with infinitesimally narrow stripe width so that the emitted electrons form an electron sheet. We next extend to three-dimensions in which electron emission is restricted to a square tile (or a circular patch) with an infinitesimally small tile size (or patch radius) so that the emitted electrons form a needlelike line charge. Surprisingly, for the electron needle problem, we only find the null solution for the total line charge current, regardless of the assumed initial electron velocity. For the electron sheet problem, we also find only the null solution for the total sheet current if the electron emission velocity is assumed to be zero, and the total maximum sheet current becomes a finite, nonzero value if the electron emission velocity is assumed to be nonzero. These seemingly paradoxical results are shown to be consistent with the earlier works of the Child–Langmuir law of higher dimensions. They are also consistent with, or perhaps even anticipated by, the more recent theories and simulations on thermionic cathodes that used realistic work function distributions to account for patchy, non-uniform electron emission. The mathematical subtleties are discussed.

1 December 2021 in Physics of Plasmas
Verified
Journal Article
Open access
PDF file
DPDrew A. Packard
Drew A. Packard
YLY. Y. Lau
Y. Y. Lau
EGE. N. Guerin
E. N. Guerin
CSC. J. Swenson
C. J. Swenson
SLS. V. Langellotti
S. V. Langellotti
RGR. M. Gilgenbach
R. M. Gilgenbach
The magnetically insulated line oscillator (MILO) is a high power microwave source that has received increased attention recently because it does not require an external magnetic field. Self-magnetic insulation typically requires operation at high currents, ∼50 kA in previous experiments (at ∼10 Ω). This paper reports the first MILO experiment operating at moderate current, less than 10 kA, at a lower voltage of 240 kV, driven by the Michigan Electron Long Beam Accelerator. The viability of this lower current operation was predicted by our recently developed theory on Brillouin flow, which also led to the rigorous derivation, for the first time, of the Buneman–Hartree condition for the cylindrical MILO using both the Brillouin flow and single particle model. The experiments show that more than 90% of shots operate at a magnetic field less than 1.3 times the Hull-cutoff magnetic field, and this magnetic field is significantly lower than the magnetic field required at the Buneman–Hartree condition. These experiments also oscillated at less current than the Hull cutoff condition on over 80% of shots, suggesting that MILOs might operate at a current lower than that expected at exactly Hull cutoff; this peculiar feature was also predicted by the theory. Particle-in-cell simulations from the improved concurrent electromagnetic particle-in-cell (ICEPIC) and CST codes are detailed, which corroborate MILO operation at lower currents than the Hull cutoff condition. The maximum efficiency achieved in these experiments is 1%, at a resonant frequency of 1 GHz. An initial comparison of the newly developed theory against prior MILO experiments is presented.

12 March 2024 in Physical Review Research
Verified
Journal Article
Open access
PDF file
DLD. Li
D. Li
KMK. G. Miller
K. G. Miller
JPJ. R. Pierce
J. R. Pierce
WMW. B. Mori
W. B. Mori
ATA. G. R. Thomas
A. G. R. Thomas
JPJohn Palastro
John Palastro
Spatiotemporal control encompasses a variety of techniques for producing laser pulses with dynamic intensity peaks that move independently of the group velocity. This controlled motion of the intensity peak offers a new approach to optimizing laser-based applications and enhancing signatures of fundamental phenomena. Here, we demonstrate spatiotemporal control with a plasma optic. A chirped laser pulse focused by a plasma lens exhibits a moving focal point, or “flying focus,” that can travel at an arbitrary, predetermined velocity. Unlike currently used conventional or adaptive optics, a plasma lens can be located close to the interaction region and can operate at an orders of magnitude higher, near-relativistic intensity. Published by the American Physical Society 2024

1 January 2023 in AIP Advances
Verified
Journal Article
Open access
PDF file
DLDion Li
Dion Li
YCYuxi Chen
Yuxi Chen
CDChuanfei Dong
Chuanfei Dong
LWLiang Wang
Liang Wang
GTGabor Toth
Gabor Toth
Collisionless magnetic reconnection typically requires kinetic treatment that is, in general, computationally expensive compared to fluid-based models. In this study, we use the magnetohydrodynamics with an adaptively embedded particle-in-cell (MHD-AEPIC) model to study the interaction of two magnetic flux ropes. This innovative model embeds one or more adaptive PIC regions into a global MHD simulation domain such that the kinetic treatment is only applied in regions where the kinetic physics is prominent. We compare the simulation results among three cases: (1) MHD with adaptively embedded PIC regions, (2) MHD with statically (or fixed) embedded PIC regions, and (3) a full PIC simulation. The comparison yields good agreement when analyzing their reconnection rates and magnetic island separations as well as the ion pressure tensor elements and ion agyrotropy. In order to reach good agreement among the three cases, large adaptive PIC regions are needed within the MHD domain, which indicates that the magnetic island coalescence problem is highly kinetic in nature, where the coupling between the macro-scale MHD and micro-scale kinetic physics is important.

1 February 2024 in Physics of Plasmas
Verified
Journal Article
Open access
PDF file
DCDavid Chernin
David Chernin
DLDion Li
Dion Li
YLY. Y. Lau
Y. Y. Lau
We consider the steady-state limiting current that can be carried by an infinite periodic array of thin electron sheets spaced by period p in a planar diode of gap voltage V and gap separation d. Our primary assumptions are as follows: (1) electron motion is restricted by an infinite magnetic field to the direction normal to the electrode surfaces, (2) all electrons are emitted from the cathode with initial kinetic energy Ein, and (3) electron motion is non-relativistic. The limiting current density, averaged over a period and normalized to the classical 1D Child–Langmuir (CL) current density (including a factor that accounts for nonzero Ein), is found to depend only on the two dimensionless parameters p/d and Ein/eV. This average limiting current density is computed from the maximum current density for which the iterative solution of a non-linear integral equation converges. Numerical results and empirical curve fits for the limiting current are presented, together with an analysis as p/d and Ein/eV approach zero or infinity, in which cases previously published results are recovered. Our main finding is that, while the local anode current density within each electron sheet is infinite in our model (that is, it exceeds the classical 1D CL value by an “infinite” factor), the period average anode current density is in fact still bounded by the classical 1D CL value. This study therefore provides further evidence that the classical 1D Child–Langmuir current density is truly a fundamental limit that cannot be circumvented.