Among the many characterization techniques for solar panel testing, two, electroluminescence (EL) and photoluminescence (PL), can provide useful visual information about the presence of different types of cell defects. EL is performed outdoors by night in commercial solar plants due to the very weak luminescence emission compared to sunlight. PL faces the added difficulty of needing to find a large‐area homogeneous light source to excite the modules. Since nighttime work poses many drawbacks and risks, a daylight outdoor EL/PL system would be useful for offering safe inspection of solar plants. We present daylight luminescence techniques based on a bias switching method, in which a pulsed luminescence signal is obtained by alternating the polarization state of the solar panels, synchronizing it with the luminescence image detection by an InGaAs camera. Fast switching and selecting an optimized exposure time are key to achieving high‐quality images. The daylight luminescence method described herein allows both EL and PL luminescence images to be obtained, even under high solar irradiance conditions.
Nowadays, photovoltaic (PV) silicon plants dominate the growth in renewable energies generation. Utility-scale photovoltaic plants (USPVPs) have increased exponentially in size and power in the last decade and, therefore, it is crucial to develop optimum maintenance techniques. One of the most promising maintenance techniques is the study of electroluminescence (EL) images as a complement of infrared thermography (IRT) analysis. However, its high cost has prevented its use regularly up to date. This paper proposes a maintenance methodology to perform on-site EL inspections as efficiently as possible. First, current USPVP characteristics and the requirements to apply EL on them are studied. Next, an increase over the automation level by means of adding automatic elements in the current PV plant design is studied. The new elements and their configuration are explained, and a control strategy for applying this technique on large photovoltaic plants is developed. With the aim of getting on-site EL images on a real plant, a PV inverter has been developed to validate the proposed methodology on a small-scale solar plant. Both the electrical parameters measured during the tests and the images taken have been analysed. Finally, the implementation cost of the solution has been calculated and optimised. The results conclude the technical viability to perform on-site EL inspections on PV plants without the need to measure and analyse the panel defects out of the PV installation.