16 February 2024 in ACS Applied Materials & Interfaces
1 February 2022 in Physics of Fluids
This work presents an experimental study on the splashing behaviors of drops impinging on rough solid surfaces. Most prior studies have shown the increase in surface roughness can promote the occurrence of a drop splash. Interestingly, we found two opposite effects of surface roughness on the drop splash that the increase in surface roughness can promote splash of low-viscosity drops but suppress splash of high-viscosity drops. According to the wetting state of the spreading lamella on rough surfaces, the splash regime can be classified into two modes: corona splash and prompt splash. It is found that the increase in surface roughness can promote the prompt splash but suppress the corona splash. The increase in surface roughness could provide wide channels for air to escape and suppress the corona splash. Meanwhile, the larger surface roughness could also disrupt the expanding lamella and promote the prompt splash. The dimensionless parameter Ohr can be used to distinguish two splash regimes, and the critical value Ohrc is obtained from experimental results, at which the splash regime changes from the prompt to corona splash. Emphatically, we obtain the splash criteria in two regions, which could reflect the opposite effects of surface roughness on the drop splash and successfully characterize the splashing behaviors in this work and previous studies. The results of this work are expected to provide valuable insights to control the drop splash in industrial applications.
1 September 2022 in Physics of Fluids
In this work, a new three-dimensional sessile droplet freezing model, involving the ice fraction and ice distribution after the droplet recalescence, is established based on the many-body dissipative particle dynamics with the energy conservation method for the first time. The proposed model is verified by comparing it with experimental results, and the accuracy of this model increases as the ice distribution becomes more non-uniform after recalescence. Furthermore, the effects of surface contact angle, droplet volume, surface temperature, and droplet supercooling degree on the freezing process are investigated in detail. The numerical results demonstrate that the angle of ice tips maintains a constant under various conditions. The upper and lower limits of solidification time under specific conditions are derived, and the droplet solidification time decreases linearly with the increase in supercooling. In addition, the average droplet solidification rate decreases with the increase in droplet volume, contact angle, and surface temperature, and the surface temperature is demonstrated to have the greatest influence on the solidification rate. Emphatically, we put forward an empirical formula, as a function of droplet volume, contact angle, droplet supercooling degree, and surface temperature, to predict the freezing time of a sessile supercooled droplet.
31 March 2024 in ACS Applied Materials & Interfaces
1 June 2026 in Physics of Fluids
This study provides a systematic experimental investigation of coalescence-induced droplet jumping during moist air condensation on superhydrophobic surfaces (SHS) under three subcooling temperatures (ΔT = 1.0, 5.5, and 10.0 °C). First, we present a large-scale statistical analysis of droplet size distribution and jumping probability, revealing that droplets <30 μm constitute ∼80% of the population and that jumping events of 10–30 μm droplets account for ∼77% of all events. Notably, the jumping probability at ΔT = 1.0 °C is significantly higher than at higher subcooling, especially for large droplets. Second, we quantitatively distinguish binary from multiple-droplet jumping: binary jumping dominates (50%–60% of events) with a wide size range (15–500 μm) but low size-mismatch tolerance (minimum radius ratio ∼0.46), while multiple-droplet jumping occurs in a narrower range (20–150 μm) with higher mismatch tolerance (minimum ratio ∼0.39). Finally, a new prediction model of the heat transfer coefficient of moist air condensation is established that incorporates relative humidity, subcooling, contact angle, and Reynolds number, exhibiting reliable predictive performance with an average prediction error of ∼8% for SHS.