12 May 2020 in Advanced Materials Interfaces
6 May 2022 in International Journal of Heat and Mass Transfer
1 August 2025 in Physics of Fluids
Electrowetting/dewetting is a highly efficient method with broad application prospects. However, the potential of using electrowetting to control droplet coalescence-induced jumping remains underexplored. In this work, electrowetting-actuated coalescence-induced droplet jumping with square pulse signal of Galinstan and water droplets was numerically investigated. The droplet jumping velocity enhancement was due to two mechanisms: the electro-wetting/dewetting enhancement mechanism and the coalescence enhancement mechanism. According to the coupling effect of two mechanisms, we defined three distinct modes: synergistic enhance mode, antagonistic enhance mode, and suppress mode. The mode phase diagram was systematically mapped to pulse width and initial voltage. The effect of pulse widths on the droplet jumping velocity was quantitatively investigated, revealing a sinusoidal oscillation behavior with gradually attenuating amplitude as the pulse width increased. The results reveal that, in the first period, an intermediate pulse width maximizes the jumping velocity and jumping efficiency, while excessively long pulses decrease additional surface energy and increase viscous dissipation, thereby suppressing jumping. A maximum normalized jumping velocity is obtained when the pulse width equals the spreading time, v* = 0.85 and v* = 0.84 for Galinstan and water droplets, which achieved the highest normalized coalescence-induced droplet jumping velocity currently. Furthermore, it was demonstrated that the contact time scales exponentially with pulse width for Galinstan and water droplets, and an empirical correlation was derived accordingly. Finally, an energy balance analysis and investigations of the pressure and velocity field were carried out to reveal the underlying mechanism of electrowetting-actuated coalescence-induced jumping behavior.
1 June 2026 in Physics of Fluids
This study provides a systematic experimental investigation of coalescence-induced droplet jumping during moist air condensation on superhydrophobic surfaces (SHS) under three subcooling temperatures (ΔT = 1.0, 5.5, and 10.0 °C). First, we present a large-scale statistical analysis of droplet size distribution and jumping probability, revealing that droplets <30 μm constitute ∼80% of the population and that jumping events of 10–30 μm droplets account for ∼77% of all events. Notably, the jumping probability at ΔT = 1.0 °C is significantly higher than at higher subcooling, especially for large droplets. Second, we quantitatively distinguish binary from multiple-droplet jumping: binary jumping dominates (50%–60% of events) with a wide size range (15–500 μm) but low size-mismatch tolerance (minimum radius ratio ∼0.46), while multiple-droplet jumping occurs in a narrower range (20–150 μm) with higher mismatch tolerance (minimum ratio ∼0.39). Finally, a new prediction model of the heat transfer coefficient of moist air condensation is established that incorporates relative humidity, subcooling, contact angle, and Reynolds number, exhibiting reliable predictive performance with an average prediction error of ∼8% for SHS.