25 July 2016 in Nature Materials
20 March 2023 in Nature Physics
The interaction between photons and a single two-level atom constitutes a fundamental paradigm in quantum physics. The nonlinearity provided by the atom leads to a strong dependence of the light–matter interface on the number of photons interacting with the two-level system within its emission lifetime. This nonlinearity unveils strongly correlated quasiparticles known as photon bound states, giving rise to key physical processes such as stimulated emission and soliton propagation. Although signatures consistent with the existence of photon bound states have been measured in strongly interacting Rydberg gases, their hallmark excitation-number-dependent dispersion and propagation velocity have not yet been observed. Here we report the direct observation of a photon-number-dependent time delay in the scattering off a single artificial atom—a semiconductor quantum dot coupled to an optical cavity. By scattering a weak coherent pulse off the cavity–quantum electrodynamics system and measuring the time-dependent output power and correlation functions, we show that single photons and two- and three-photon bound states incur different time delays, becoming shorter for higher photon numbers. This reduced time delay is a fingerprint of stimulated emission, where the arrival of two photons within the lifetime of an emitter causes one photon to stimulate the emission of another.
5 July 2023 in Nature Communications
Rapid, high-fidelity single-shot readout of quantum states is a ubiquitous requirement in quantum information technologies. For emitters with a spin-preserving optical transition, spin readout can be achieved by driving the transition with a laser and detecting the emitted photons. The speed and fidelity of this approach is typically limited by low photon collection rates and measurement back-action. Here we use an open microcavity to enhance the optical readout signal from a semiconductor quantum dot spin state, largely overcoming these limitations. We achieve single-shot readout of an electron spin in only 3 nanoseconds with a fidelity of (95.2 ± 0.7)%, and observe quantum jumps using repeated single-shot measurements. Owing to the speed of our readout, errors resulting from measurement-induced back-action have minimal impact. Our work reduces the spin readout-time well below both the achievable spin relaxation and dephasing times in semiconductor quantum dots, opening up new possibilities for their use in quantum technologies.
27 May 2021 in Physical Review Applied
A splitting of the fundamental optical modes in micro- and nanocavities comprising semiconductor heterostructures is commonly observed. Given that this splitting plays a role in light-matter interaction and hence quantum technology applications, a method for controlling the mode splitting is useful. In this work we use an open microcavity composed of a “bottom” semiconductor distributed Bragg reflector (DBR) incorporating a -- heterostructure, paired with a “top” curved dielectric DBR. We measure the mode splitting as a function of wavelength across the stopband. We demonstrate a reversible in situ technique to tune the mode splitting by applying uniaxial stress to the semiconductor DBR. The method exploits the photoelastic effect of the semiconductor materials. We achieve a maximum tuning of approximately GHz. The stress applied to the heterostructure is determined by observing the photoluminescence of quantum dots embedded in the sample, converting a spectral shift to a stress via deformation potentials. A thorough study of the mode splitting and its tuning across the stopband leads to a quantitative understanding of the mechanism behind the results.
1 April 2021 in Physical Review Applied
We present a surface-passivation method that reduces surface-related losses by almost 2 orders of magnitude in a highly miniaturized open microcavity. The microcavity consists of a curved dielectric distributed Bragg reflector with radius of approximately paired with a -based heterostructure. The heterostructure consists of a semiconductor distributed Bragg reflector followed by an -- diode with a layer of quantum dots in the intrinsic region. Free-carrier absorption in the highly--doped and highly--doped layers is minimized by our positioning them close to a node of the vacuum electromagnetic field. The surface, however, resides at an antinode of the vacuum field and results in significant loss. These losses are much reduced by surface passivation. The strong dependence on wavelength implies that the main effect of the surface passivation is to eliminate the surface electric field, thereby quenching below-band-gap absorption via a Franz-Keldysh-like effect. An additional benefit is that the surface passivation reduces scattering at the surface. These results are important in other nanophotonic devices that rely on a -vacuum interface to confine the electromagnetic field.
21 August 2024 in Physical Review Letters
A quantum emitter interacting with photons in a single optical-mode constitutes a one-dimensional atom. A coherent and efficiently coupled one-dimensional atom provides a large nonlinearity, enabling photonic quantum gates. Achieving a high coupling efficiency ( factor) and low dephasing is challenging. Here, we use a semiconductor quantum dot in an open microcavity as an implementation of a one-dimensional atom. With a weak laser input, we achieve an extinction of 99.2% in transmission and a concomitant bunching in the photon statistics of , showcasing the reflection of the single-photon component and the transmission of the multi-photon components of the coherent input. The tunable nature of the microcavity allows to be adjusted and gives control over the photon statistics—from strong bunching to antibunching—and the phase of the transmitted photons. We obtain excellent agreement between experiment and theory by going beyond the single-mode Jaynes-Cummings model. Our results pave the way towards the creation of exotic photonic states and two-photon phase gates.