This study examines the dielectric properties of filled PVDF film and filled PVDF-TrFE film incorporated with 1, 3, 5, and 7 weight percentages of magnesium oxide (MgO) nanofillers. The metal-insulator-metal (MIM) configuration demonstrates PVDF/MgO with 7 weight percent of MgO which produced high dielectric constant (1 kHz) with low dielectric loss. The ATR-FTIR spectra of PVDF/MgO (7%) indicate wide bonding peaks at 840 cm-1 and 880 cm-1, assigned to -CH2 and -CF2 groups, respectively. This implies the presence of high content of β-crystals in the PVDF/MgO (7%) film. A shift in the peak was observed in the same film, from 1170 cm-1 to 1180 cm-1 suggesting possible transformation from γ-crystals to β-crystals. This film showed no apparent defect on its film surface. Thus, it established that PVDF incorporated with 7% MgO can be used to produce nanocomposite thin film for low-frequency electronic devices.
The annealing temperature for 250 nm PVDF-TrFE (70:30 mol %) spin coated thin films were varied at solvent evaporation (Ts = 79 °C), Curies transition (Tc= 113 °C), till melting temperature (Tm = 154 °C). XRD measurement showed that, there was an improvement in the crystallinity of the annealed films, consistent with the increased in the annealing temperatures. Morphological studies of the annealed PVDF-TrFE thin films as observed with Field Emission Scanning Electron Microscope (FESEM) (100k magnification), showed enhanced development of elongated crystallite structures known as ferroelectric crystal. However, thin film annealed at 160 °C (AN160) showed fibrous-like structure with appearance of nanoscale separations, which suggested high possibility of defects. Ferroelectric characterization indicated an improvement in the remnant polarization of annealed PVDF-TrFE thin films with the exception to AN160 in which leakage of current was inevitable due to the presence of cracks on the film surface.
This study investigates the effect of varying loading percentage of MgO on the dielectric constant of Poly (vinylideneflouride)/Magnesium Oxide (PVDF/MgO) nanocomposite thin films. PVDF/MgO nanocomposite spin coated thin films were successfully fabricated and characterized. PVDF and nanocomposites solutions with loading percentage of MgO at 3, 5, 7, 9, and 11% were spin coated on Al-glass substrates at 1500rpm. The optimum percentage of PVDF/MgO thin film obtained from the dielectric measurement was 7%. The dielectric constant of PVDF/Mg(7%) nanocomposite at frequency 10 3 Hz was 21, with low dielectric loss and absence of visible film defects, as evident by FE-SEM images. In FTIR, broad bonding peaks at 840 and 880 cm -1 can be observed. Both bonding represented the -CH 2 and -CF 2 groups of PVDF, which indicated high β-phase content that attributed to the increment in the dielectric constant of PVDF/MgO(7%) nanocomposite. The PVDF/MgO(7%) nanocomposite is favorable for low frequency electronic application such as capacitor.
This study investigates the surface properties of plasma surface modified spin coated PVDF-TrFE (70/30) film using Atomic Force Microscopy (AFM), Water Contact Angle (WCA) and X-ray Photoelectron Spectroscopy (XPS). The surfaces of the spin coated PVDF-TrFE film were modified using 13.56 MHz rf Argon plasma. The exposure time of the charged particle PVDF-TrFE films were varied for 1, 3 and 5mins. Prior to modification, the average surface roughness obtained was 8.615nm, but upon modification, the surface roughness was found to increase to 12.466nm. The value of the contact angle of the modified film was reduced from 90oto 43oand the XPS analysis showed dehydrofluorination of PVDF-TrFE films surfaces.The improved in surface roughness and the increased in wettability of the modified film, resulted in good biocompatibility of the modified PVDF-TrFE thin films. This phenomenon has created interest in researchers for developing functional polymer used for applications in areas such are biomedical, bio-analytical assays, textile and even food industry.
The morphology of PVDF-TrFE (70/30) thin film at various annealing temperature were investigated using non-contact mode Atomic Force Microscopy (AFM). Differential Scanning Calorimetry (DSC) technique was used to obtain T C , T m , and T Crys of PVDF-TrFE. The prepared spin coated PVDF-TrFE (70/30) thin films were annealed at T C (113°C), T m (154°C), T Crys (135°C) and T c at cooling (55°C) in accordance to the DSC thermogram observed. Impedance Spectroscopy were conducted to study the dielectric characteristic of the thin films in order to substantiate the electrical behavior of the thin films From the results obtained, the thin films exhibited different morphologies depending on the annealing temperatures utilized. Formation of needle-like crsytallite structure was observed film annealed at and over T m . Thin film re-crystallized at T C has an optimized dielectric constant of ~7.8 at 10 4 hz.
22 May 2017 in Advances in Materials and Processing Technologies
This study investigates the effect of ZnO nanofillers loading ratios on Polyvinylideneflouride-Triflouroethylene/Zinc Oxide (PVDF-TrFE/ZnO) nanocomposites thin films; filled single layer and bilayer film. Both films were produced using a spin coater with ZnO nanofillers of weight percentages 1, 3, 5 and 7%. These films were characterized for their crystal phase change via ATR-FTIR and electrical properties using I-V measurement. The ATR-FTIR for both single layer and bilayer nanocomposites films showed three distinguished peaks at absorption bands of 1400, 1290 and 848 cm−1, evident of the β-phase PVDF-TrFE crystals. The resistivity value recorded for the bilayer PVDF-TrFE/ZnO nanocomposites thin films were significantly higher in comparison to the filled single layer PVDF-TrFE/ZnO nanocomposites film. At 1 wt%, the resistivity value for PVDF-TrFE/ZnO bilayer thin film was 4.34 × 105 Ω cm, relative to 1.50 × 105 Ω cm resistivity value, for the single layer film. Therefore, it is established in this study that PVDF-TrFE/ZnO bilayer film showed enhanced resistivity property at small loading percentage of ZnO nanofillers, suggests that the bilayer film is suitable to be utilized as a dielectric film for storage devices.